This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Do not expose the batteries to excessive heat such as sunshine, fire or the like.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE
If the shape of the plug does not fit the power outlet, use an attachment plug
adaptor of the proper configuration for the power outlet.
Replace the battery with the specified type only. Otherwise, fire or injury may
Dipose of used batteries according to the instructions.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
To comply with FCC RF exposure requirements, the following antenna
installation and device operating configurations must be satisfied: the antenna
has been installed by the manufacturer and no change can be made.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
The available scientific evidence does not show that any health problems are
associated with using low power wireless devices. There is no proof, however,
that these low power wireless devices are absolutely safe. Low power Wireless
devices emit low levels of radio frequency energy (RF) in the microwave
range while being used. Whereas high levels of RF can produce health effects
(by heating tissue), exposure to low-level RF that does not produce heating
effects causes no known adverse health effects. Many studies of low-level RF
exposures have not found any biological effects. Some studies have suggested
that some biological effects might occur, but such findings have not been
confirmed by additional research. This device (HID-B70) has been tested
and found to comply with FCC radiation exposure limits set forth for an
uncontrolled equipment and meets the FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
Connect the AC adaptor to an easily accessible wall outlet close by. If
trouble occurs while using the adaptor, immediately shut off the power by
disconnecting the plug from the wall outlet.
Do not use the AC Adaptor placed in a narrow space, such as between a wall
To disconnect the AC power adaptor cord (mains lead), pull it out by the
plug, not the cord.
Do not leave the unit in a location near a heat source such as a radiator or
air duct, or in a place subject to direct sunlight, excessive dust, mechanical
vibration, or shock.
Allow adequate air circulation to prevent internal heat build up. Do not
place the unit on a surface (a rug, a blanket, etc.) or near materials (a
curtain) which might block the ventilation holes.
Should any solid object or liquid fall into the unit, unplug the unit and have
it checked by qualified personnel before operating it any further.