TABLE OF CONTENTS Important Safety Instructions Assembly of Your Recliner Recliner Assembly Troubleshooting FCC Instructions Serial Label Customer Service Note: When placing the furniture on non-carpeted flooring, it is recommended to use some type of floor protection such as an area rug or furniture pads under the chair glides. Area rugs and padding are not included with purchase.
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING. WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons: DANGER: To reduce the risk of electric shock-Always unplug this furnishing from the electrical outlet before cleaning. Unplug from outlet before putting on or taking off parts. Close supervision is necessary when used by or near children, or disabled people.
RECLINER ASSEMBLY ATTACHING THE RECLINER BACK TO THE RECLINER BASE Wing Metal Inserts Figure A Back Receivers Steel Metal Sleeves Mechanism Figure D Post Figure C.1 Screwdriver required (not included) Figure B Lumbar Figure C.2 Figure C.3 Headrest Note: your unit may look different in appearance from the one shown in the illustrations on this instruction sheet. CAUTION: PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTING ASSEMBLY PROCESS.
TROUBLE SHOOTING PROBLEM POSSIBLE FACTORS SOLUTIONS Check the power supply has been Recliner doesn't recliner or lift Transformer may not connected correctly connected to socket well Confirm the wire from chair to transformer is firmly connected Headrest or Lumbar doesn’t work Headrest or lumbar motor may not Check the headrest and lumbar motor connected well...
Serial Label Your serial number label at the rear of the chair , as the below picture. contact your retailer. Serial Label Serial Label Customer Service If you have any questions regarding the use of this unit or find that your unit need service, please contact your retailer Product Protected By Following Patents: Patented Articulating Power Headrest &...
Page 8
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,including interference that may cause undesired operation of the device. Modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
Need help?
Do you have a question about the Recliner Series and is the answer not in the manual?
Questions and answers