Advertisement

Quick Links

VULCANIC SA
Types 80812/14/34/40
48, rue Louis Amp?re - Zone Industrielle des Chanoux
48, rue Louis Amp?re - Zone Industrielle des Chanoux
48, rue Louis Ampère – Zone Industrielle des Chanoux
T?l. (33) 01.49.44.49.20 - Fax (33) 01.49.44.49.41
T?l. (33) 01.49.44.49.20 - Fax (33) 01.49.44.49.41
Tél. : (33) 01.49.44.49.20 – Fax : (33) 01.49.44.49.41
AIR CONDITIONERS FOR
ELECTRICAL CABINETS
PLEASE READ CAREFULLY AND FULLY THIS MANUAL BEFORE
INSTALLING THE UNIT THIS MANUAL IS AN INTEGRAL PART
OF THE PRODUCT AND SHOULD ACCOMPANY IT UNTIL
VULCANIC S.A.
VULCANIC S.A.
VULCANIC S.A.
F 93330 NEUILLY / MARNE (France)
F 93330 NEUILLY / MARNE (France)
F – 93330 NEUILLY SUR MARNE (France)
E.mail : catalogue-vulcanic@vulcanic.com
E.mail : catalogue-vulcanic@vulcanic.com
Web : www.vulcanic.com
E-mail :
catalogue-vulcanic@vulcanic.com
Web : www.vulcanic.com
Web : www.vulcanic.com
VERTICAL
ITS POSSIBLE DISASSEMBLY.
UT 80812/14/34/40 GB ind B. - 15/10/2004
Instruction Manual
G
B
B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 80812 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VULCANIC 80812

  • Page 1 AIR CONDITIONERS FOR ELECTRICAL CABINETS PLEASE READ CAREFULLY AND FULLY THIS MANUAL BEFORE INSTALLING THE UNIT THIS MANUAL IS AN INTEGRAL PART OF THE PRODUCT AND SHOULD ACCOMPANY IT UNTIL ITS POSSIBLE DISASSEMBLY. UT 80812/14/34/40 GB ind B. - 15/10/2004...
  • Page 2: Table Of Contents

    START-UP PROCEDURE: ................... 9 USE OF ELECTRONIC REGULATOR: ......................... 10 6.1. ADJUSTMENT OF REGULATION PARAMETERS: ....................11 6.2. OPERATION TEST DIODES:............................12 6.3. ALARM MESSAGES: ................................. 13 6.4. MAINTENANCE: ................... 14 GUARANTEE: ..................... 14 Page 2/14 – UT 80812/14/34/40 GB ind B. – 15/10/2004...
  • Page 3: Introduction

    VULCANIC SA Types 80812/14/34/40 CONGRATULATIONS! By choosing a VULCANIC cabinet air conditioner, you have opted for equipment that has been the focus of our attention during its manufacturing in our plant at Neuilly-sur-Marne, near Paris, as well as during the individual test procedures; all these operations take place according to certification by ISO 9001.
  • Page 4: Description

    VULCANIC SA DESCRIPTION: To ensure traceability concerning the ISO 9001 certification, each VULCANIC air conditioner has a C.E identification plate riveted to the housing, bearing its reference and essential technical characteristics. The model describes briefly the technical characteristics of the air conditioner: more explicitly than the reference.
  • Page 5: Choice Of Location

    Trace the Ø 8 attaching holes and the air passage holes on the side panel or door of the cabinet where the air conditioner will be installed, as indicated in the following sketches. Drill and cut according to the trace. Glue the seals to the perimeter of the cut holes. UT 80812/14/34/40 GB ind B. – 15/10/2004– Page 5/14...
  • Page 6 3 trous Ø 8 Climatiseur A/C unit CA 85 à 250 air conditioners Oblong seal Rectangular seal 4 holes dia. 8 A/C unit CA 85 CA 120 CA 170 CA 210 CA 250 Page 6/14 – UT 80812/14/34/40 GB ind B. – 15/10/2004...
  • Page 7: Installing The Air Conditioner On The Cabinet

    Use the 2 supplied TORX screws to attach the deflector of the blowing vent, using the holes drilled specifically for the purpose. 5.2. ELECTRIC CONNECTION: The CA range circuit breakers are cabled according to the diagrams of the following table. Contact VULCANIC to obtain any necessary information concerning these diagrams and their nomenclature: MODEL REFERENCE DIAG. No...
  • Page 8 50Hz contact transfer 400 V AC SINGLE PHASE AIR CONDITIONERS Alarm Connector Alarme Connecteur Alarm Door transfer contact Report Contact 400 V mono alarme de porte 50Hz Page 8/14 – UT 80812/14/34/40 GB ind B. – 15/10/2004...
  • Page 9: Start-Up Procedure

    “- - -” for 5 seconds, then indicates the temperature measured inside the cabinet to be air- conditioned. If there is no fault, the alarm transfer contact closes between terminals 7 and 88 of the interface connector and the evaporation fan begins to rotate. UT 80812/14/34/40 GB ind B. – 15/10/2004– Page 9/14...
  • Page 10: Use Of Electronic Regulator

    , to the right of the LED described above. • Alarm, symbolised by the pictogram , at the bottom left of the display. Normally, the display indicates the temperature measurement in °C Page 10/14 – UT 80812/14/34/40 GB ind B. – 15/10/2004...
  • Page 11: Adjustment Of Regulation Parameters

    To enter the adjuster menu press simultaneously on SET then on for 3 seconds while the measurement is displayed. The display indicates the first parameter “Con” in the adjuster menu while the LEDs are flashing. UT 80812/14/34/40 GB ind B. – 15/10/2004– Page 11/14...
  • Page 12: Operation Test Diodes

    - CoF = Duration of compressor stoppage periods in minutes, when the air conditioner is operating with power wave trains that are constant because of a probe fault - Pr2 = changeover to configuration menu reserved for VULCANIC and protected by a confidential access code. Note: The CoF parameter is adjusted by default to a value of 4 minutes.
  • Page 13: Alarm Messages

    The message “EE” is displayed when a software problem occurs. Press on any key. if the display indicates “rSt” for 3 seconds, the air conditioner becomes operational again immediately. Otherwise return the regulator to VULCANIC for repair. UT 80812/14/34/40 GB ind B. – 15/10/2004– Page 13/14...
  • Page 14: Maintenance

    Wear caused by a lack of maintenance, impact, clumsy or inexperienced users, Use of a filter (condenser cooling air inlet) different from the one recommended by VULCANIC, Failure to comply with this manual, the professional practice rules and the legislation, and phenomena of corrosion or fouling are not binding on the liability of VULCANIC.

This manual is also suitable for:

808148083480840

Table of Contents