Envisacor Tecnologies SOLO ENVV00019 Installation & Operation Manual

Federal Communications Commission Statement
This equipment has been followed to comply with Part 15 of the FCC Rules. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try and correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna,
-Increase the separation between the equipment and receiver,
-Connect the equipment into and outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesirable
operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
Limited Warranty
Envisacor Guarantees that every wireless door/window sensor is free from physical
defects in material and workmanship under normal use for one year from the date of
purchase. If the product proves defective during this one-year warranty period, Envisacor
will replace it free of charge. Envisacor does not issue any refunds. This warranty is
extended to the original end user purchase only and is not transferable. This warranty
does not apply to: (1) damage to units caused by accident, dropping or abuse in handling,
or any negligent use; (2) units which have been subject to unauthorized repair, taken
apart, or otherwise modified; (3) units not used in accordance with instruction; (4)
damages exceeding the cost of the product; (5) transit damage, initial installation costs,
removal cost, or reinstallation cost.
ENVV00019 V0 1090506
Installation & Operation Manual
ENVV00019
Door/ Window Sensor