Ninja StaySharp Quick Start Manual

What's in the Box
20cm Chef
13cm Utility
Knife Block
Chef Knife
Slicing Knife
Bread Knife
Utility Knife
Paring Knife
Suction Cups
(Underneath Block)
Cleaning & Care
HAND WASH ONLY. DO NOT place knives in
Hand wash your Ninja dishwasher. Dishwashers can
knives to maintain reduce performance and
optimal performance. longevity of your knives and
damage the handles and blades.
Dry knives thoroughly
Wipe knife block to
before storing to
clean with a damp,
prevent watermarks and
not wet, dish towel
spotting. DO NOT touch
or paper towel.
sharp edge of knife.
©2023 NINJA and NINJA STAYSHARP are registered trademarks in the United Kingdom of
SharkNinja Operating LLC.
K62006EUUK_QSG_MP_U8_UK_230706_MV2
20cm Bread 20cm Slicing
9cm Paring Scissors
Scissors
Sharpening Slot
Release
Button
Sharpener
Lever
Stone
Sharpening
Wheel Access
Door
Shears separate into two
pieces for cleaning. Fully
open Scissors with blades
pointing away from you,
then pull the piece with
the hole off the bolt.
For best results, clean
stone sharpening wheel
every 6 months with
running water and
a soft bristle brush.
Replace every 2 years.
Please make sure to read the enclosed Use and Care Guide prior to using.
StaySharp
Knife System
Sharpening Guide
IMPORTANT: Knives arrive sharp. DO NOT sharpen immediately. DO
NOT attempt to sharpen wet or unclean knives. To maintain optimal
sharpness, follow the sharpening steps at least every 2 weeks.
TO SHARPEN:
1. Slide lever to bottom of knife block.
2. Insert clean Ninja knife into designated sharpening slot until the blade comes
to a hard stop.
LARGE HANDLE
Insert into upper sharpening slot
(Chef and Slicing Knives)
3. While lightly holding the inserted knife,
down 10 times.
A slight click will be heard when the lever travels all the way
to the top and bottom of the block.
NOTE: The lever must travel the full length of
the block to sharpen, regardless of knife size,
as shown here. The upstroke positions the
stone sharpening wheel and the downstroke
sharpens the knife.
4. Ensure the lever is at the bottom of the block.
release button while carefully removing the knife
5. Rinse and dry knife thoroughly after sharpening to remove metal shavings.
If knife has not been returned to preferred sharpness, repeat steps above.
Quick Start
Guide
SMALL HANDLE
Insert into lower sharpening slot
(Utility and Paring Knives)
slide the lever all the way up and
X10
Push down and hold the