Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Vetra Skalapp DV
- Page 1 Skalapp DV Quick User’s Manual...
-
Page 2: Table Of Contents
Contents Using the manual ....................................3 Scope of installation ..................................3 Description of the installation ............................... 4 Intended use of the scale ................................4 Important points to ensure scale accuracy .......................... 4 Scale maintenance ..................................5 Manufacturers liability ................................5 Safety instructions ................................... -
Page 3: Using The Manual
Using the manual Read this entire manual before operating the scale and keep the instructions in an easily accessible location. If you misplace it, please request a new one from us. Ensure these instructions are available to all persons using the scale. The scale operator is responsible for training all personnel who will use the scale. -
Page 4: Description Of The Installation
Description of the installation The scale consists of one or two loadcells placed in a weighing frame built into the belt conveyor structure. Loadcells provide input for calculating the load on the material belt. There is also an encoder in the construction of the conveyor that measures the movement of the conveyor... -
Page 5: Scale Maintenance
Scale maintenance • Only original spare parts and accessories approved by the manufacturer may be used. • Carry out a regular optical check of the scale and all relevant components for damage. • Only persons trained and authorized by the manufacturer may repair the scale. •... -
Page 6: Switching The Scale On, Weighing
Switching the scale on, weighing There is no need to start the scale in any way, the scale is connected directly to the machine's electrical circuit and is always switched on when the machine is in operation. Weighing runs automatically, immediately after starting the belt (unless the summation was stopped before). -
Page 7: Overview
Main screen buttons In the case of monitoring multiple conveyors, you can switch between them using the arrows in the upper right corner • „Overview“ - displays the current performance of all connected conveyors at once • „Order data“ – displays a list of orders, allows you to switch orders or create a new one •... -
Page 8: Zero Setting
Zero setting By zero, the scale adapts to new operating conditions (typically temperature or changed belt tension). For accurate weighing, it is necessary to set zero regularly, ideally before starting work – e.g., in the morning after starting the machine/line. 1. -
Page 9: Troubleshooting
Troubleshooting The scale works, but does not summarize Check the belt speed and loadcell readings on the display at the bottom. The belt speed must be approx. 1.0 m/s – approx. 2.0 m/s, if the display shows 0, verify that the measuring wheel touches the belt and is not blocked and call the service. - Page 10 +420 379 731 698 Pod Korábem 727 info@skalapp.com 345 06 KDYNĚ www.skalapp.com Czech Republic Skalapp is a registered trademark of VETRA International s.r.o. The General Terms and Conditions and Licensing Terms of VETRA International s.r.o. apply and can be downloaded from https://www.vetrainternational.cz/gtc_2025/.
-
Page 11: Eu Declaration Of Conformity
EU DECLARATION OF CONFORMITY Name and address of the manufacturer issuing the declaration: VETRA International s.r.o. Pod Korabem 727 345 06 Kdyne Czech Republic Tel: +420 379 731 698 Type designation Skalapp DV Product description Continuous totaliser - conveyor belt scale...
Need help?
Do you have a question about the Skalapp DV and is the answer not in the manual?
Questions and answers