Advertisement
Quick Links
Advertisement
Summary of Contents for SMAI B001-V2-5
- Page 1 Model No. B001-V2-5 B001-V2-6 SPORTS MASTER ATHLETIC INTERNATIONAL...
- Page 2 1. IDENTIFY AND LAYOUT FRAME PIECES Unpack all frame components, and identify the frame components according the matching number system. Frame components are engraved with numbering 1 - 12. Correctly lay out and align the frame pieces by placing matching numbers together. Note the position of the posts.
- Page 3 IMPORTANT! ESSENTIAL FOR INSTALLING THE FLOOR PANELS LATER! When laying out the frame pieces, note the small half circle tabs on the top of the frame. These tabs must be positioned so they are facing outwards from the ring. If the tabs are facing inwards to the ring, you must flip and realign your frame edge panels, so the tabs are facing outwards from the ring.
- Page 4 3. INSTALL CENTRE FRAME BRACE Identify the 3 support posts (parts A & B) and 2 cross beams (part C) to be used as the first cross beam structure Note the centre post (part A) has a different base shape and different connection bracket to the left and right support posts (part B).
- Page 5 Support legs A + B in position Cross Beams (C) Installed in position SPORTS MASTER ATHLETIC INTERNATIONAL...
- Page 6 4. INSTALL TURNBUCKLES Install the frame turn buckles. There are 4 turnbuckles for the frame. Attach the turnbuckles to the bottom of each frame corner, to the centre post. Unscrew the U buckle, then reattach the buckle using the screw to the fitting on the corners and centre post. IMPORTANT! Do not tension the turnbuckles until each is installed! Tensioning the turnbuckles early will cause the frame to buckle.
- Page 7 5. INSTALL REMAINING CROSS BEAMS Lay out the remaining 6 cross beams, this time running perpendicular to the beams you installed earlier. Each beam will rest on a leg in the centre, and align with a pin hole on the outer edge of the frame.
- Page 8 6. INSTALL FLOORING PANELS Identify the floor panels using the attached diagram. Corner floor panels (A & B) will feature a cut out to allow space for the corner post, white the centre floor panels (C) will not feature the cutout. Note the position of the A, B &...
- Page 9 8. LAY OUT CANVAS OVER FRAME Locate the canvas floor cover, unfold and lay out over the flooring panels and frame. Logo side should be facing up. Stretch out canvas by fixing Velcro tabs through the frame middle bar. Move around the canvas, stretching and fixing as you go.
- Page 10 9. ATTACH SHORT TURN BUCKLE TO POSTS Locate 12 short turnbuckles, and fix to corner posts. Attach 4 turnbuckles to each post, starting from the top position, and working downwards. Fully open / extend the turnbuckles after they are installed. Note in diagram, which end is attached to the post. On posts with 6 notches, use the top 4 notches only.
- Page 11 10. CONNECT ROPES THOUGH TURNBUCKLE Unscrew the D Shackle on each turnbuckle and feed the ropes through the shackle, and reattach screw to fix rope to the turnbuckle. Move around the ring corners, connect the ropes. NOTE: Ropes should be loose and un-tensioned during fitting! Once the ropes are fed through all turnbuckles, begin tensioning the ropes by turning each turnbuckle evenly.
- Page 12 BOXING RING COMPETITION ASSEMBLY...
Need help?
Do you have a question about the B001-V2-5 and is the answer not in the manual?
Questions and answers