Puqpress Mythos Quick Start Manual

Handle
Installation set-up with Mythos
with 2
people!
1. Slide the back of Puqpress M2 over the edge of 2. While lifting the Mythos to place on Puqpress
the table or bar where you want to use your set-up. M2, guide the Mythos cable from top to bottom
through Puqpress.
Connect the Puqpress cable inside in its socket.
All manuals and user guides at all-guides.com
3. Choose 1 of 3 directions to guide both cables out. Press the 4. Carefully slide the set-up back onto the bar or table and
Puqpress cable in the cable-guide behind the clip. Position the make sure its standing level.
Mythos cable in the other cable-guide (without clip).
Hey there!
Set up the Lower Clamp, before you do anything else.
Only then, every tamp will be perfectly level and safe.
Set-up
Cleaning during your shift
with 2
people!
For instruction videos check www.puqpress.com/support
Coffee can stick to your tamper while
making coffees. Give it a quick wipe
with a dry towel or cloth and you're
good to go again!