TABLE OF CONTENTS PRODUCT INFORMATION Important Safeguards Overview Parts List Remote Control GETTING STARTED Registration and Functions & Features Installation Resources PRODUCT INSTALLATION Installation Guide Questions? We’re here to help. MAINTENANCE 847.458.2334 Removing The Discovery DLS support@biobidet.com Cleaning The Discovery DLS www.biobidet.com Extended Travel Specifications...
IMPORTANT SAFEGUARDS GENERAL CAUTIONS • To prevent burns, avoid using the “high” or “medium” seat temperature and PLEASE OBSERVE THE FOLLOWING PRECAUTIONS warm air settings for extended periods. AND INSTRUCTIONS BEFORE INSTALLATION AND USE. • Keep your skin near the seat sensor during use to ensure uninterrupted •...
REMOTE CONTROL Adjustable Front, Top, and Back Side Stop Button Nozzle Position NOZZLE Front Wash Nozzle Clean CLEAN DYNAMIC Rear Wash Dynamic Stream STREAM NIGHT Warm Air Dryer LED Night Light LIGHT Adjustable DRYER Auto Clean TEMP Air Temperature Adjustable WATER OPEN/CLOSE Open/Close Lid &...
FUNCTIONS & FEATURES Warm Air Dryer Reduce the need for toilet paper with a built in adjustable warm air dryer. Press to activate the warm air dryer. Adjust the fan speed to your liking. Operating Your Discovery DLS The dryer automatically turns off after 4 minutes. •...
Page 7
DYNAMIC Dynamic Stream Power/Stop Button (Side button) STREAM Press “Dyanmic Stream” during a wash cycle to activate a wash that Turn the bidet on/off by pressing the “Power/Stop” button on the side. quickly alternate between warm and cold water. This feature assists in Short press to power on or long press to enter standby mode.
INSTALLATION GUIDE 3. Install Catch Plate Insert the rubber anchors into the mounting holes. Place the catch plate and guides over each mounting hole. Insert the mounting screws through the bolt guides, catch CAUTION BEFORE INSTALLATION plate, and into the rubber anchors. Fasten the catch plate to the toilet tank. Do not plug in before installation.
Page 9
5. Connect the Water Hose *Shut-off valve may vary. If supplied parts do not fit, please call 847.458.2334. Alternate fittings are available upon request. Install the t-valve on to the toilet tank. Ensure the rubber gasket is Toilet Tank properly seated inside the t-valve. Connect the provided toilet hose to the water shut-off valve and t-valve.
MAINTENANCE SPECIFICATIONS Removing the Discovery DLS Specifications Discovery DLS Model Discovery DLS Rated Voltage 120 V, 60 Hz Rated Power 1050 W Release Button Waterproof Guide IP X 4 Seat Temperature Off / 93.2 - 102.2°F Disconnect the power plug. Close water supply shut-off valve.
Product’s purchase price (less shipping, if applicable), at Bemis’s option. Bemis may, at its option, require the return of any Product for inspection and testing before hon- oring any defect claim. This Limited Warranty excludes component parts not specified by Bemis, and excludes costs related to shipping and labor, including removal, disposal, repair, or replace- ment of the defective Product and installation of replacement Product (if applicable).
Page 12
THANK YOU! Bio Bidet Innovation LLC T: 847.458.2334 TOLL-FREE: 877.339.5214 7900 S IL Route 31 Crystal Lake, IL 60014 support@biobidet.com www.biobidet.com REV. 1...
Need help?
Do you have a question about the BIOBIDET DISCOVERY DLS and is the answer not in the manual?
Questions and answers