1. Manuals
  2. Brands
  3. Mastercook Manuals
  4. Grill
  5. SRCG32410
  6. User manual

Mastercook SRCG32410 User Manual

Dual function gas + charcoal smoker bbq
Hide thumbs

Advertisement

Table of Contents

R
DUAL FUNCTION
GAS + CHARCOAL SMOKER BBQ
Product size assembled:
PLU: 154734
H1175 x W1735 x D605mm
Model No.: SRCG32410
User Manual
2575-25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SRCG32410 and is the answer not in the manual?

Questions and answers

Related Manuals for Mastercook SRCG32410

Summary of Contents for Mastercook SRCG32410

  • Page 1 DUAL FUNCTION GAS + CHARCOAL SMOKER BBQ Product size assembled: PLU: 154734 H1175 x W1735 x D605mm Model No.: SRCG32410 User Manual 2575-25...
  • Page 2 Imported by: OGALAS ULC D12 ECR9 2575-25 Tel: +353 1 427 6500 Product Name Model No. MASTERCOOK DUAL FUNCTION SRCG32410 GAS + CHARCOAL SMOKER BBQ Serial Number PIN Number 9.35KW (682g/h) 2575DP42693 ∑Qn Injector Size Injector Size Country Gas & Pressure...

  • Page 3: General Information

    GENERAL INFORMATION Safety and Care Advice (Gas BBQ) IMPORTANT: Please read these instructions fully before starting assembly and using the appliance. WARNING: Whilst every effort has been made in the manufacture of your barbecue to remove any sharp edges, care should be taken in handling to avoid any accidental injury. Use outdoors only.
  • Page 4 GAS AND REGULATOR This barbecue can use either propane or butane or propane/butane mixed LPG (liquid petroleum gas) bottled gas. Propane bottles will supply gas all year round, even on cold winter days. Butane bottles will supply sufficient gas in summer, but it may affect the performance of the barbecue and restrict the heat output available from the burners, particularly once the gas temperature starts to fall below +10°C.

  • Page 5: Installation

    INSTALLATION Selecting a Location This barbecue is for outdoor use only and should be placed in a well-ventilated area, and on a safe and even surface. Never place your barbecue below ground level. Take care to ensure that the barbecue is used on an incombustible floor.
  • Page 6 If the barbecue still fails to light, please refer to the manual ignition instruction in the section below. • After ignition, the burner should be burned at the high position for 3-5 minutes, in order to preheat the • barbecue. This process should be done before every cooking session. The hood (where applicable) should be open during preheating.
  • Page 7 Flare-up Control *Very Important Notice* Flare-ups occur when meat is barbecued and its fat and juices fall upon the hot flame tamer. Smoke of course helps give food its barbecued flavour, but it is best to avoid excessive flare-ups to prevent food becoming burned.

  • Page 8: Care And Maintenance

    CARE AND MAINTENANCE Regularly clean your barbecue between uses and especially after extended periods of storage. Ensure the barbecue and its components are sufficiently cool before cleaning. Do not leave the barbecue exposed to outside weather conditions or stored in damp, moist areas. Never douse the barbecue with water when its surfaces are hot.

  • Page 9: Barbecue Body

    Barbecue Body Regularly remove excess grease or fat from the barbecue body using a cloth wrung out in hot soapy water and dry thoroughly. Excess fat and food debris can be removed from inside the body using a soft plastic or wooden scraper.

  • Page 10: Carbon Monoxide Hazard

    Cover the burners with aluminium foil in order to prevent insects or other debris from obstructing the burner holes. If the barbecue is to be stored indoors, the gas bottle must be disconnected and left outside. The gas bottle should always be stored outside, in a dry, well-ventilated area, away from any sources of heat or ignition.
  • Page 11 GENERAL INFORMATION Safety and Care Advice (Charcoal BBQ) IMPORTANT: Please read these instructions fully before starting assembly and using the appliance. WARNING: Whilst every effort has been made in the manufacture of your barbecue to remove any sharp edges, care should be taken in handling to avoid any accidental injury. •...
  • Page 12 ALWAYS WEAR OVEN GLOVES WHEN HANDLING THE CHARCOAL BBQ. • We recommend using a maximum of 1.5kg of charcoal briquettes on the charcoal grate. Excess • charcoal will make the barbecue too hot for cooking. Ensure the barbecue has cooled down completely before removing the charcoal ash. •...

  • Page 13: Troubleshooting

    TROUBLESHOOTING Problem Solution Possible Cause Burner will not light LP gas cylinder is empty Replace with full cylinder using the ignition Faulty regulator Have regulator checked or replaced system Obstructions in burner Clean burner Obstructions in gas jets or gas hose Clean jets and gas hose Electrode wire is loose or disconnected Reconnect wire...

  • Page 14: Fixtures And Fittings

    Fixtures and Fittings Components supplied (not actual size) Components supplied (not actual size) Description Visual Description Visual Side burner Right front leg assembly Side burner Right rear leg control panel Cart right Knob bracket Cart front/ Grease cup rear bracket Control Condiment panel assembly...
  • Page 15 Description Visual Description Visual Windscreen Warming rack Burner with Lid handle ignition B urner w/o Charcoal grill lid ignition Temperature Heat tent gauge Charcoal tray Chimney assembly Firebox assembly for Chimney lid small box Side handle Gas grill lid Gas/Charcoal Heat shield cooking grill Firebox...
  • Page 16 Fittings supplied (not actual size) Description Visual M6*12mm Bolt M4*8mm Bolt Spring M4*15mm Bolt M5*10mm Bolt M6 nut M6 Cap nut M6*15 Bolt M6*35 Bolt R pin M4*8 Tapping screw Axle...
  • Page 18 Assembly instructions A x 4 M6*12mm Bolt A x 4 M6*12mm Bolt...
  • Page 19 Assembly instructions A x 8 M6*12mm Bolt A x 4 M6*12mm Bolt...
  • Page 20 Assembly instructions A x 4 M6*12mm Bolt A x 4 M6*12mm Bolt...
  • Page 21 Assembly instructions J x 2 R pin L x 2 Axle A x 4 M6*12mm Bolt...
  • Page 22 Assembly instructions J x 3 R pin K x 3 M4*8 Tapping screw...
  • Page 23 Assembly instructions 5 11 5 12 A x 4 M6*12mm Bolt...
  • Page 24 Assembly instructions A x 4 M6*12mm Bolt...
  • Page 25 Assembly instructions 5 14 Flange D x 2 M4*15mm Bolt E x 2 M5*10mm Bolt 5 15 A x 4 M6*12mm Bolt...
  • Page 26 Assembly instructions 5 16 Do not tighten all the bolts until the below steps have been completed. Pre-assemble one M6x12 bolt (A) onto the left rear leg (7) and do not tighten it. Make sure to leave a 5mm gap between the bolt and the left rear leg.
  • Page 27 Assembly instructions 5 17 B x 2 M4*8mm Bolt 5 18 Make sure the tip of the valve is completely inside the burner venturi.
  • Page 28 Assembly instructions 5 19 H x 14 M6*15 Bolt Pre-assemble five M6x15 bolts (H) onto the small box lid and do not tighten them. Make sure to leave a 5mm gap between the bolts and the small box lid. Then hang the small box assembly on the grill cabinet assembly.
  • Page 29 Assembly instructions H x 2 M6*15 Bolt A x 4 F x 4 M6*12mm Bolt M6 nut C x 1 G x 1 Spring M6Cap nut...
  • Page 30 Assembly instructions H x 2 M6*15 Bolt A x 8 M6*12mm Bolt...
  • Page 31 Assembly instructions A x 8 M6*12mm Bolt K x 2 M4*8 Tapping screw...
  • Page 32 Assembly instructions...
  • Page 33 Assembly instructions I x 4 M6*35 Bolt 5 30...
  • Page 34 Assembly instructions 5 31 5 32...
  • Page 35 Assembly instructions 5 33 5 34 Assembly is complete. ALL JOINTS AND CONNECTIONS MUST NOW BE LEAK TESTED BEFORE USING THE BARBECUE. Leak test annually, and whenever the gas bottle is removed or replaced. Please refer to Leak Testing in pg.5 Always place the gas bottle at the side of the appliance.

Table of Contents