Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for ARB CANDEC
- Page 1 ARB CAN Connect USER GUIDE Revision Date: July 1, 2024...
- Page 2 Running Lights), indicators lights, and also reverse lights and brake lights. 12V switched outputs - The ARB CAN Connect is plugged into a vehicle CAN bus where it will listen for pre- programmed signals associated with the vehicles lighting. It is equipped with 11 x 12V outputs that are capable of powering 12V low wattage lights such as LED parkers and indicators, or a 12V signal for higher wattage driving lights.
-
Page 3: Specifications
Module Installation WARNINGS The ARB CAN Connect must be installed in a clean and dry environment, e.g. inside the vehicle cabin. The device is not suitable for outside installation. Ensure all electrical connectors and wiring loom are secured away from sharp edges, moving parts and hot surfaces. -
Page 4: Harness Installation
⑦ terminal onto the plastic pipe and pull the pipe with wires into the engine bay. 4. Inside the vehicle cabin route and connect the 8 pin plug ⑩ into the ARB CAN Connect module. Revision Date: July 1, 2024... - Page 5 5. As described in the ARB CAN bus adaptor harness instructions (various), connect the Ground ⑧ onto a suitable body ground point. 6. Connect the CAN bus Plug & Play connector ⑨ into the ARB CAN bus adaptor harness (sold separately).
- Page 6 13. For driving light applications with parker light signal, join the DL Parker wire ⑤ to the ARB driving light loom. 14. Route and connect the Ground ⑥ onto a suitable body ground point in the engine bay. 15. Locate the supplied loom with fuse holder and ring terminal.
-
Page 7: Troubleshooting
Play. Turn the vehicle ignition on and the ARB CAN Connect should also turn on, and the status LED should be flashing. Open the ARB CAN Connect app and follow the app instructions to configure ARB CAN Connect for your vehicle. Note that the module may beep during configuration. -
Page 8: Compliance Information
(2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution Changes or modifications not expressly approved by ARB Corporation for compliance could void the user's authority to operate the equipment. EU DECLARATION OF CONFORMITY 1. - Page 9 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Need help?
Do you have a question about the CANDEC and is the answer not in the manual?
Questions and answers