Little Giant HB130 Installation Instructions

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS
WARNING!
When using electrical appliances, basic precaustions should always be followed, including the following:
• Read all the instructions before using the appliance.
• To reduce risk of injury, close supervision is necessary when the appliance is used near children.
• Do not contact moving parts.
• Only use attachments recommended by the manufacturer.
• Intended for outdoor use only in a dry sheltered area.
• Do not unplug by pulling on cord. To unplug grasp the plug, not the cord.
• Unplug from outlet when not in use and before servicing or cleaning.
• Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or is
dropped or damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair, or electrical or mechanical adjustment.
• To reduce risk of electric shock, do not put near or in water or other liquid.
• Place heated base directly on a non-combustible surface in a dry sheltered area.
CAUTION
TO PROVIDE CONTINUED PROTECTION AGAINST ELECTRIC SHOCK:
1. Have a qualified electrician install a properly grounded GFCI
receptacle outlet, acceptable for outdoor use and protected from
snow and rain, immediately adjacent to the location where the
heater will be used.
2. Route the supply cord and locate the heater so as to be protected
from damage by livestock.
3. Do not use extension cords.
4. Inspect cord before using.
5. Unplug heater at receptacle outlet when not in use.
6. Store heater indoors after winter season
7. The supply cord cannot be replaced. If the cord is damaged the
appliance should be scrapped.
8. Place only metal pan or metal poultry/pet fount on surface marked "TOP".
9. The maximum weight capacity is 80 lbs and any fount, pan, or bowl which can be
placed on the unit should not exceed 14" in diameter.
SAVE THESE INSTRUCTIONS
EACH HEATER BASE CONTAINS
• 110W, 120VAC heating element
• Thermostat control turns on and off automatically for economical operation
• Fully assembled and ready to use
OPERATING INSTRUCTIONS
• Place heated base directly on a flat, non-combustible surface in a dry sheltered area
• Plug it into GFCI outlet
• Place metal fount, bowl or pan on top of unit
Heater Base
Item # HB130 and HB140
IMPORTANT SAFETY INSTRUCTIONS
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
Place Object
on Top
1002415
Installation Instructions