Sionyx Nightwave Digital Quick Start Manual

Quick Start Guide
Box Contents
1x Nightwave Digital
1x PoE Injector
Cables & Connectors
1x Camera cable (10m)
1x Network ethernet cable (2m)
1x Power 2/16 cable (2m)
2x RJ45 terminal
1x Cable zip tie
Tools, Screws, Fittings
1x 7/16-inch open end wrench
1x 3/16-inch hex key (large)
1x 2 mm hex key (small)
1x 3/32-inch screwdriver
1x #3 Phillips bit, 1/4-inch hex shank
1x Ethernet cable grommet
1x RJ45 DIY camera connector
4x #12 flat washer
4x #12 mounting screw
6x M3x0.5x10mm cover screw
Determine the Best Install Location
AF Flat, level mounting
AT
surface that won't
weaken the boat's
structure
Mounting Options
A)
A) Screw from under surface into base plate
above, or B) through base plate onto surface.
Cable Routing Options
A)
Route cable through A) baseplate and
surface, or B) exit from the edge of the
device, across the surface.
Get More Information
View Complete
Installation Guide
Read BEFORE Installation
Minimize obstructions
Highest possible
to camera's field of
view
B)
B)
More than 1m from
any interference
location
source (magnetic
compass, radio, radar,
generator, motor)
Install right-side-up or
upside-down.
Ensure cable length and routing is
adequate for installation location
interference (radios, radar, generators,
motors).
Continued on Flip Side