Advertisement
Advertisement
Table of Contents
Summary of Contents for Des Champs Technologies EU PROFI 24 EGGS
- Page 1 USER MANUAL Incubator EU PROFI 24 EGGS...
-
Page 2: Table Of Contents
TABLE OF CONTENT Installation Temperature & Humidity Settings Eggs & Turning Egg Candler & Hatching Factory Settings & Cleaning... -
Page 3: Installation
Installation Choosing the Right Location for Your Incubator Incubation room environment can have a considerable effect on hatch rate. The incubator need to be placed in a room with stable temperature between 72°-80°F. Pay attention to the room temperature to ensure that it doesn't drop below 70°F particularly at night. -
Page 4: Temperature And Humidity
Temperature & Humidity Adjusting Temperature & Hatching Days This incubator is factory pre-set to 9 9 . 5F and 21 hatch days for chicken eggs. Upon plugging theincubator into power, the timer wil immediately begin ot countdown from 21 days and thetemperature wil gradually increase to 99.5 °... -
Page 5: Settings Eggs & Turning
Set Eggs Settings Eggs & Turning Betore setting eggs, ensure the incubator has been run for 4~5 hours with water filling into water pot "1". Also allow stored eggs to naturally warm up 6~8 hours to room temperature prior to putting into incubator. This will minimize the condensation on egg surtace. How to easily set eggs into the yellow egg carrier ? It would be incovenient to set the eggs into the yellow egg carriers, if th egg carriers stop at the inclined position (image A). -
Page 6: Egg Candler & Hatching
Egg Candler & Hatching Using the Built-in Egg Candler Gently place the large end of egg into the candling zone. Press the candling button and observe the interior of the egg. Tips: - Dimming room light will make observation easier - During candling, the room temperature is much lower than that in the incubator, for this reason, it's recommended to complete candling in less than 5 minutes. -
Page 7: Factory Settings & Cleaning
Factory Settings & Cleaning Returning to Factory settings Resseting the incubator will return it to the factory settings of 99.5F and 21 hatch days. To reset the incubator, press and hold both "DAY" and " - " buttons for more than 3 seconds, the incubator will beep and the display will blink one time, indicating that the incubator has successfully been reset. - Page 8 Contact Us! Retailer Adress Retailer Phone Number Retailer E-mail...
Need help?
Do you have a question about the EU PROFI 24 EGGS and is the answer not in the manual?
Questions and answers