MAXSA PARK RIGHT 37310, 37310-RS, 37310-W-RS Manual

Included Parts

1- Garage Laser Park with Mounting Bracket
1- AC Adapter (120V AC input, 9V DC output)
3- Screws
2- Double-Stick Tape

Setting Up

1. Find a suitable mounting location close to an electrical outlet (typically the outlet used to power your garage door opener). The mounting location should be inaccessible to children or pets. Detach the white mounting bracket from the main unit. Attach the mounting bracket to the ceiling or wall as shown with the 3 screws or double-stick tape. Be sure the bracket is oriented correctly; if you are mounting it on the ceiling, the arrow shown below on the mounting bracket should point towards the garage door; if you are mounting it on the wall, it should point towards the ground.
   
   Do NOT use double-stick tape to mount the unit on a ceiling. Mount securely with screws.
   
2. The battery is only a backup if power is interrupted and it will not last for more than a few days. To install the backup battery, remove the battery compartment door and install 1 9V battery, matching the correct +/- polarity as shown in the compartment.
3. Slide the main unit into the black mounting bracket as shown.
   
4. Plug in the AC adapter.
5. Park your car in the desired position. Adjust the laser beam so that it shines on a prominent feature on your car. Good choices include a spot on the dashboard or the space between the hood and the windshield. Remember, you must be able to see the spot from the driver's seat while parking the car. Do not allow the laser beam to reflect off a shiny surface and into your eyes.
   
6. When your car first enters the garage, the motion detector will turn on the laser. Drive forward until the laser beam for your vehicle hits your pre-determined spot indicating that you are parked in the correct position. The laser will turn off automatically after you are parked.

Troubleshooting

The Garage Laser Park laser may sometimes appear to stay on permanently and never turn off. The Garage Laser Park turns on each time it senses motion. It can be triggered by any movement in the garage such as a door opening, an animal moving, or a car entering the garage. As a result, a homeowner may think that the laser never turns off. In these cases what is usually happening is that each time the homeowner looks in the garage, the laser is triggered when the door is opened. If you believe that the laser is not turning off, please check it in a way that the motion sensor will not be triggered.
For assistance, please visit our site: www.maxsainnovations.com Or contact customer service: 703-495-0661