Advertisement
Table of Contents
DVS
VR07-020
DE
Montage- und Betriebsanleitung
EN
Installation and operating instructions
FR
Notice de montage et de mise en service
ES
Instrucciones de montaje y servicio
IT
Istruzioni per il montaggio e l'uso
NL
Montage- en bedrijfsinstructies
PL
Instrukcja montażu i obsługi
SV
Monterings- och driftinstruktion
CS
Návod pro montáž a provoz
FI
Asennus- ja käyttöohje
RU
Инструкции по установке и
эксплуатации
PP00-654 V1.0 250324
Product name DE
Product name EN
Product name FR
Product name ES
Product name IT
Product name NL
Product name PL
Product name SV
Product name CS
Product name FI
Product name RU
Product name
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for KWC DVS VR07-020
- Page 1 VR07-020 Montage- und Betriebsanleitung Product name DE Installation and operating instructions Product name EN Notice de montage et de mise en service Product name FR Instrucciones de montaje y servicio Product name ES Istruzioni per il montaggio e l’uso Product name IT Montage- en bedrijfsinstructies Product name NL Instrukcja montażu i obsługi...
- Page 2 - 2 -...
- Page 3 Version. INFL002 v2.0 180511 HDTX806L Flushvalve WC Flushing System V2 with the Fully Automatic Sensor Model: D103/V2/AUTO Dart Valley Systems Tel: +44 (0) 1803 529021 Fax: +44 (0) 1803 559016 www.dartvalley.co.uk Installation and operating instructions HDTX806M VR07-020 - 3 - - 3 -...
- Page 4 HDTX806L These instructions relate to the use of the Washroom Control System only, any external or ‘add-on’ parts will be supplied with separate instructions. The electrical part of the installation MUST be carried out by a qualified electrician in accordance with the latest electrical regulations.
-
Page 5: Installation
Installation EN Installation NL Montage CS Montáž FR Montage PL Montaż FI Asennus ES Montaje SV Montering RU Монтаж IT Montaggio The Control System Box should be located in a dry location and not exposed to dirt, dust or damp. The unit should be accessible when required, but not within easy general reach of unauthorised persons. - Page 6 1. Mains Out By default the channels are programmed for the 2. WC Valve Channel 11 below products. 3. WC Sensor Channel 11 4. WC Valve Channel 12 1. Basin (Tap) Hot 5. WC Sensor Channel 12 2. Basin (Tap) Cold 6.
- Page 7 The unit should be securely fixed in a suitable location in a vertical orientation with the glands pointing down, so that the front label can be read correctly. Open lid to expose four fixing holes around the edge of the enclosure. These holes allow the fastening of the unit without removing the printed circuit board.
- Page 8 After all external equipment is installed, the mains supply can be connected. When connecting to mains always make sure that the lid is tightly closed and secure. NEVER open the cover with the supply live. When the control unit is first powered on, the power light will illuminate to show that the control box is active. - 8 -...
- Page 9 Flushvalve WC Flushing Sy with the Fully Automa Model: D103/V2/AUTO DEFAULT OPTIONAL SETTINGS SETTINGS Typically used with WAVE FLUSH VALVE MENU WC01 - 023 or WC01 - 022 Flush type Single Single or dual WC Flushvalve Flush time(s) 4 seconds 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5 seconds Range Automatic purge OFF, 3, 6, 12, 24, 36, 48, 72 hours...
- Page 10 The automatic purge is enabled through the Front Panel Menu. The default setting is disabled. See Menu Settings guide (Step 7) for instructions on how to enable this feature. When the purge feature is enabled each channel (Flushvalve, Hot and Cold Water and Shower) is independently monitored.
- Page 11 LUSH VALVE MENU WAVE FLUSH VALVE MENU Flush Type Single Single or Dual Single Single or Dual Single me(s) 4 Seconds Flush Time(s) 4 Seconds 4 Seconds 2, 2.5, 3, 3.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6 & 6.5 Seconds Range c Purge Automatic Purge...
-
Page 12: Product Disposal
Product disposal EN Installation NL Montage CS Montáž FR Montage PL Montaż FI Asennus ES Montaje SV Montering RU Монтаж IT Montaggio The use of this crossed out wheeled bin logo indicates that this product needs to be disposed of separately to any other household waste. -
Page 13: Product List
Product list EN Installation NL Montage CS Montáž FR Montage PL Montaż FI Asennus ES Montaje SV Montering RU Монтаж IT Montaggio The following parts are compatible with the VR07 - 020 Washroom Control System. The actual parts supplied ... - Page 14 AC02-047 - Tactile switch with 50mm stainless steel bezel and Red insert (Hot) AC02-046 - Tactile switch with 50mm stainless steel bezel and Blue insert (Cold) ...
- Page 15 - 15 -...
-
Page 16: Other Countries
Australia Italy United Kingdom PR Kitchen and KWC Austria GmbH KWC DVS Ltd - Northern Office Water Systems Pty Ltd 6971 Hard, Austria Barlborough S43 4PZ Dandenong South VIC 3175 Numero Verde +39 800 789 233 Phone +44 1246 450 255...
Need help?
Do you have a question about the DVS VR07-020 and is the answer not in the manual?
Questions and answers