Summary of Contents for RRT MARKSMAN
- Page 1 O P E R A T I N G I N S T R U C T I O N S FULLY READ THE WARNINGS BEFORE OPERATING! Visit Gun Dog Supply.com | Order a RRT Marksman Launcher | See other RRT Products...
- Page 2 - NEVER insert a live load into the chamber. - NEVER use a load other than a green/low and yellow/medium 1776 Blank (those specifically designed and recommended for) in the RRT Launcher. - NEVER aim or fire the Marksman Remote Launcher Unit at anyone or anything.
- Page 3 - NEVER cock and fire the Marksman Remote Launcher Unit without a cartridge in the chamber. - NEVER fire the RRT Hand Held Launchers if the exhaust hole in any of the shaft/barrels is/are obstructed in any way. Also ensure the barrel is free of debris before every launch.
- Page 4 TIME TO ASSEMBLE YOUR LAUNCHER 1) Remove the 2 end plates from the packaging and place them so the wording “RRT LAUNCHER” is readable left to right by assembler. 2) Install the round bottom bars using the 4 round thumb screws. The split lock washer is placed on the thumb screw first followed by the flat washer.
- Page 5 1990 to present. A compatable launcher may have a ribbed rubber hand grip and a plastic or aluminum pull knob. If you recently purchased a new RRT Launcher it will have RRT LAUNCHER on the grip and you can SKIP STEP ONE ON THE FOLLOWING PAGE.
- Page 6 1) The rubber grip on launchers prior to 2014 will require trimming in order to fit into the Marksman Launcher Tube. On the base of the grip (end closest to the pull knob) the lip of the grip must be trimmed.
- Page 7 If another receiver harness is desired for a left or right port you may contact RRT Launcher or go to our website www.RRTLAUNCHER.com to purchase a 2nd harness for your receiver.
- Page 8 UNDER SIDE OF THE LAUNCHER TUBES. TIME TO MOVE TO YOUR OUTDOOR TRAINING GROUND 1) Place your Marksman where you will be using it for your training session. ENSURE THAT IT IS FULLY LEVEL AND NEVER USE ON UNEVEN GROUND! 2) Install any RRT Dummy onto each launcher.
- Page 9 CONNECTING HARNESS! 4) Close the breech of the RRT Hand Held Launcher. NOTE: The thumb latch must be held in the open position when the head is closed. Once the head is closed to the breech, release the thumb latch and push the latch to ensure it has fully seated thus locking the head closed.
-
Page 10: Maintenance
Also thoroughly clean and dry the inside of the aluminum dummy tube after each launch. Be certain that prior to each time you launch the dummy from your Marksman Remote Launcher System that it is free of debris both internally and externally. Failure to properly maintain the aluminum insert... - Page 11 HAVE QUESTIONS? If you do not understand the instructions or have further questions regarding the use and operation the Marksman Remote Launcher System please discontinue use and contact Specialty Products Company USA. PHONE - (570)-729-7192 EMAIL - info@rrtlauncher.com...
-
Page 12: Limitation Of Liability
TLB Industries. Inc. /Specialty Products Company reserves the right to change the terms, conditions under which this product is offered without further notice. Visit our website for more great products and accessories for your Marksman Remote Launcher at www.RRTLauncher.com...
Need help?
Do you have a question about the MARKSMAN and is the answer not in the manual?
Questions and answers