Related Manuals for Progetto PLY25
Summary of Contents for Progetto PLY25
- Page 1 INSTALLATION INSTRUCTIONS PLY25 VANITIES, MIRROR CABINETS & WALL TOWERS IMPORTANT! Please read these instructions prior to installation Distributed by: T 04 568 9898 E sales@plumbline.co.nz www.plumbline.co.nz...
- Page 2 Care & Conditions Of Use Progetto Bathroom Furniture products are manufactured from the finest materials and when treated with care will last many years. Vanity Tops/Basins Vanity tops must not be subjected to water temperatures above the recommended safety level of 55° Celsius.
-
Page 3: General Installation Instructions
General Installation Instructions Important! It is recommended that a qualified, licensed tradesperson install your unit. This unit carries a full warranty against faulty workmanship and material. Prior to installation it is important to inspect the unit to ensure no defects or no damage has occured in transit as the warranty does not cover the cost of removal and installation once installed. - Page 4 Vanities Important! Before installing ensure there is sufficient timber framing in the wall to securely fasten your vanity to. Before starting remove the drawer from the cabinet (refer to the Drawer Adjustment & Removal Instructions section of this document) Recommended Wall Vanity Mounting Height 840-900mm 1.
- Page 5 Vanities 3. Make the necessary holes/cutouts in the vanity top for the basin & waste. Install the basin and re-fit the drawer. Sealing Important! Before use a bead of sealant must be used to seal all edges where water penetration may occur - between cabinet and wall and between cabinet and basin.
- Page 6 Mirror & Mirror Cabinets Important! Before installing ensure there is sufficient timber framing in the wall to securely fasten your cabinet to. Ply25 Mirrors & Mirror Cabinets hang off a 'french cleat' 1. Determine the measurement from the top of the that is screwed to the wall, see illustration below.
- Page 7 Installing Demister Pads Important! Any electrical connections and possible subsequent electric interventions must only be done by a qualified electrician who will operate in accordance with current regulations in terms of electricity. 1. Remove the back panel of the mirror by removing the 2.
- Page 8 Wall Towers Important! Before installing ensure there is sufficient timber framing in the wall to securely fasten your wall tower to. Before starting remove the door from the cabinet (refer to the Door Adjustment & Removal Instructions section of this document) 1.
- Page 9 Drawer Adjustment & Removal Instructions Cabinet drawers will need to be removed prior to the installation of the cabinet. Incorrect removal of the drawer will result in damage to the soft close mechanism. Drawer Removal Drawer Installation Drawer Adjustment - Horizontal Drawer Adjustment - Vertical...
- Page 10 Drawer Adjustment & Removal Instructions Drawer Adjustment - Tilt Drawer Front Removal...
- Page 11 Door Adjustment & Removal Instructions Cabinet doors will need to be removed prior to the installation of the cabinet. Door Removal Door Installation Door Adjustment - Skew Door Adjustment - Depth Door Adjustment - Height...
-
Page 12: Warranty Information
IMPORTANT NOTE: Under no circumstances tile vanity cabinets and/or tops ‘into’ the wall. Progetto vanity cabinets & tops must be fitted to finished wall coverings. The Warranty does not cover any vanity and/or top that has been tiled ‘into’ a wall i.e., fitting or fixing a vanity to a wall and tiling into the side and around it, and/or tiling down and/or around the vanity top.
Need help?
Do you have a question about the PLY25 and is the answer not in the manual?
Questions and answers