Behringer BIGFOOT Manual
Also See for BIGFOOT:

Advertisement

Behringer BIGFOOT Manual

BIGFOOT Controls

Controls Overview

  1. CAPSULE – This area is where the microphone diaphragms pick up sound.
  2. GAIN – This knob adjusts the level of the microphone's output signal through the USB or PHONES output.
  3. PATTERN – Depending on your recording needs, use this rotary switch to choose between four polar patterns: Stereo, Omnidirectional, Cardioid or Bidirectional.
  4. MUTE – Press this button to mute off the microphone's output. When muted, the LED embedded in the button will light up red. When unmuted, the LED will light green and show normal operation/ bus-power is active.
  5. VOLUME (PHONES) – Turn this knob to adjust the output volume for the PHONES jack.
  6. PHONES – This output connects to headphones with 1/8" stereo plugs. Use this output to monitor your microphone sound in real time with no latency.
  7. USB – Connect the microphone to a computer with a USB cable.
  8. THREAD – Mount the microphone on a standard microphone stand by using the built-in mounting thread. If necessary, remove the reduction thread to adapt the mounting to your tripod.

BIGFOOT Getting Started

Quick Setup

  1. Set the microphone so that the MUTE and VOLUME controls are facing you in your recording position.
  2. Tighten the screws on either side to keep the microphone at your chosen angle.
  3. Run the supplied USB cable from the USB output on the bottom to your computer.
  4. Be sure to select BIGFOOT as your audio device for recording/playback in your computer.
  5. While speaking or playing into the microphone, watch the input meter of your recording software or interface. Use the GAIN knob to increase or decrease the signal from the microphone, depending on the level shown in your meter, until you find a usable level.

Drivers

The microphone should run automatically when plugged into your computer's USB input without need for any further drivers.

Recommended Operating Systems:
Windows*: Windows 10 (64-bit)
Mac**: OS X 10.10 or higher
*Windows is either a registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.
**Mac/Macintosh and OS X are either registered trademarks or trademarks of Apple Computers in the United State and/or other countries.
If necessary, you can download the universal ASIO4ALL USB driver for Windows for free by going to the download section on the BIGFOOT product page.
BIGFOOT may also work with iOS, Android and Linux devices, depending on your specific hardware and operating system version. For example, if your smartphone supports USB On-The-Go and delivers sufficient power to run the microphone, then you should be able to use BIGFOOT in mobile recording situations.

Polar Patterns

The BIGFOOT microphone has four different polar patterns that can be selected with the PATTERN switch:
Polar Patterns

  1. STEREO – The stereo polar pattern captures left and right channels. This pattern is ideal for acoustic guitars.
  2. OMNIDIRECTIONAL – The omnidirectional polar pattern picks up sound equally from every direction and is good for capturing room ambience.
  3. CARDIOD – The cardioid pattern is an excellent all-purpose pattern that strongly picks up sound sources from directly in front of the capsule, which is good for vocals and instruments when you wish to limit the amount of room ambience picked up by the microphone.
  4. BIDIRECTIONAL – A bidirectional polar pattern picks up sounds from both the front and rear of the microphone, while limiting the amount of sound picked up from the sides. This pattern is useful for two-person interviews or podcasts when you only have one microphone.

Specifications

System
Transducer type Condenser, 3 x 14 mm capsules
Frequency range 20 Hz to 20 kHz (-10 dB)
Max. SPL 120 dB (1% THD @ 1 kHz)
Sample rate 48/44.1 kHz
Bit rate 16-bit
Controls
Polar pattern 1 x rotary switch Stereo/Omnidirectional/Cardioid/Bidirectional, selectable
Gain -∞ to +17 dB
Mute On/off, switchable
Headphone Amplifier
Max. power output 305 mW
THD 0.05%
Frequency response 20 Hz to 20 kHz
Signal-to-noise 75 dB
Connections
Headphone out 1 x 1/8" TRS, stereo
Impedance 10 Ω, 1 kHz balanced
USB connection 1 x mini-B
Mains Voltage/Fuse
Supply voltage 5 V via USB port
Dimensions/Weight
Dimensions (H x W x D) 110 x 110 x 227 mm (4.3 x 4.3 x 8.9")
Weight 1.7 kg (3.74 lbs)

Other important information

  1. Register online.
    Please register your new Music Tribe equipment right after you purchase it by visiting musictribe.com. Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable.
  2. Malfunction.
    Should your Music Tribe Authorized Reseller not be located in your vicinity, you may contact the Music Tribe Authorized Fulfiller for your country listed under "Support" at musictribe.com. Should your country not be listed, please check if your problem can be dealt with by our "Online Support" which may also be found under "Support" at musictribe.com. Alternatively, please submit an online warranty claim at musictribe.com BEFORE returning the product.

Important Safety Instructions


RISK OF ELECTRIC SHOCK!
DO NOT OPEN!

shock hazard Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality professional speaker cables with ¼" TS or twist-locking plugs pre-installed. All other installation or modification should be performed only by qualified personnel.
shock hazard This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure - voltage that may be sufficient to constitute a risk of shock.
warning This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. Please read the manual.

To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside. Refer servicing to qualified personnel.

To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. The apparatus shall not be exposed to dripping or splashing liquids and no objects filled with liquids, such as vases, shall be placed on the apparatus.

These service instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operation instructions. Repairs have to be performed by qualified service personnel.

  1. Read these instructions.
  2. Keep these instructions.
  3. Heed all warnings.
  4. Follow all instructions.
  5. Do not use this apparatus near water.
  6. Clean only with dry cloth.
  7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
  8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
  9. Do not defeat the safety purpose of the polarized or grounding-type plug.
    A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
  10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
  11. Use only attachments/ accessories specified by the manufacturer.
  12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
  13. Unplug this app aratus during lightning storms or when unused for long periods of time.
  14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
  15. The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection.
  16. Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
  17. Do not install in a confined space, such as a book case or similar unit.
  18. Do not place naked flame sources, such as lighted candles, on the apparatus.
  19. Please keep the environmental aspects of battery disposal in mind. Batteries must be disposed-of at a battery collection point.
  20. This apparatus may be used in tropical and moderate climates up to 45°C.

Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street, Las Vegas NV 89118, United States
Phone Number: +1 702 800 8290

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Behringer BIGFOOT Manual

Advertisement

Need help?

Need help?

Do you have a question about the BIGFOOT and is the answer not in the manual?

Questions and answers

Table of Contents