JRL FF 2020T Manual

Product specifications

How to charge your trimmer

As shown in the figure, the power cord can be connected directly to the trimmer to charge.

Note: When the trimmer is low on charge, the adapter can be plugged onto the trimmer directly. You may use the trimmer while it is charging.

LED functions
When the trimmer has less than 10 minutes of usable time, the JRL warning light flashes in red.

When the trimmer has more than 10 minutes of usable time, the JRL warning light flashes in white.

When the trimmer is fully charged, the warning light will stop flashing and the white JRL light will remain on

Instructional use

Switching and shifting instructions
Push the switch to turn the trimmer on and off.

O: Shutdown
l: Power on, 7,200 RPM

Trimmer status indication by LED light

• The JRL LED light shows the usable time of the trimmer in the current speed setting.
• When the trimmer is in high power mode, the JRL white light is on.
• When the trimmer is in medium power mode, the JRL red light is on.
• When the trimmer battery is low, the JRL red light will flash.
• Trimmer will automatically shut down/off when battery is dead.

How to adjust cutting length to 0 mm

• Before operating, please make sure the machine is turned off.
• After the blade is installed, be sure to carefully check whether the corresponding parts have been firmly attached.
• Do not try to sharpen or alter the blade by yourself to avoid damaging your machine.

Loosen the screws clockwise to adjust to the gap you need.

Check the upper and lower blades are centred and parallel.

Blade maintenance

Note:

1. Please read the blade maintenance Instructions carefully before operating. Follow the instructions when removing and installing the blade to avoid improper assembly.
2. After the blade is installed, be sure to carefully check whether the corresponding parts have been firmly attached.
3. Before operating, please unplug the power adapter and turn off the trimmer.
4. When handling the blade, do not try to sharpen or alter the blade by yourself to avoid damaging your trimmer.

Removing your blade
As seen in figure 1, hold the bottom blade with your fingers to avoid the blade from moving. Loosen the screws and remove the blade. Make sure you hold the blade and the trimmer when disassembling to prevent parts from falling and getting damaged.

Installing your blade
As shown in the figure 2, align the screw slots corresponding to the blade and main unit of trimmer.
Tighten the screws. Then the installation of the blade is complete.

Blade Cleaning and maintenance
Figure 3. Use a brush to clean the main unit & the hair debris on the blade.

Figure 4. Drop drops of lubricant oil to the corresponding five areas.

How To Restore The Blade

1. Loosen the screws shown, and remove the blade
   
   
   the blade is very sharp. Pay attention to protect your hands
2. Hold the upper blade and push it down to reset it, then tighten the screws and adjust the gap as you need.
   

Warranty

1. Under normal conditions of proper use and maintenance of the product, the warranty period of the product is 1 year.
2. Expendable parts, such as blades, guards, lubricants, cleaning brushes, etc., are not under the terms of the warranty.
3. The following conditions are not covered by the warranty service:

• Failure to show a valid warranty card, or the information on the warranty card is inconsistent with the actual product.
• Trimmers with alterations will not be covered by the warranty service.
• Proof of purchase must be included with warranty card.
• Failure to follow the instructions in the instruction manual to operate and maintain the trimmer, causing it to malfunction or damage it by dropping the trimmer, immersing the trimmer in water and physical alterations of any kind will void the warranty service.
• Product damage due to transportation or improper storage.

4. This warranty card is the only warranty certificate, please store it properly along with your proof of purchase.
5. The company will charge a maintenance fee for products without a warranty card or beyond the warranty period.
6. Please send the trimmer in need of repair or warranty directly to the designated JRL domestic service center for repair, maintenance, or replacement

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download JRL FF 2020T Manual