Related Manuals for Anker SOLIX EverFrost 2
Summary of Contents for Anker SOLIX EverFrost 2
- Page 1 What's in the Box Overview Installing the Battery Using Your Cooler Powering On/Off Screen Guide Using the App Settings Powering Your Cooler USB-C Solar Panel (100W Max, 12V-30V) Maintenance Best Practices Specifications Warranty Policy...
- Page 2 What's in the Box Anker SOLIX EverFrost 2 58L Car Charging Cable AC Adapter and Charging Electric Cooler Cable Wheel Holder Battery Compartment Important Information (×2) Drawer Overview...
- Page 3 Cooler Cover Circulating Fan Tray Table* Note: Load capacity is 30 kg (66 lb). Bar** Note: For accessories such as rod and knife racks, tabletops, and cups, align the protruding strip at the back of the accessory with the notch on the bar and insert it fully. Refer to the accessory instructions for details.
-
Page 4: Installing The Battery
Installing the Battery · If there is already a battery in the cooler, please skip this step. · The cooler can be installed with one or two batteries. When using one battery, please install it in the right battery compartment. Do not place any objects in the empty battery compartment to avoid contamination of the internal battery contact pins, which could lead to poor battery contact or a short circuit. - Page 5 Press for 3 seconds to turn your cooler on or off. < > Screen Guide Protective Voltage (M/H/L) Eco/Smart/Max Mode Fault Code* Zone A Temperqture Zone B Temperqture Battery Level of Secondary Battery Child Safety Lock Press once to turn the child safety lock on/off. <...
- Page 6 Motor Fan Overcurrent Motor Overspeed Motor Blocked at Startup Motor Phase Loss Motor Voltage Drop Communication Error Detected by MCU Cooler Tilt Angle Greater Than 30° Using the App Connecting the Cooler 1. Connect with Wi-Fi and download the app to remotely control your cooler. 2.
- Page 7 4. We recommend that you connect to Wi-Fi to use the cooler for a better experience. After connecting to Wi-Fi successfully, the icon on the screen will change from < > to < >. Installing Firmware Updates You will receive a notification before updates are installed. Your cooler must be charging and connected to Wi-Fi or Bluetooth to complete the update.
- Page 8 Setting the Zone Press to enter the Settings page, press and <the OK button> to select zones. Press to turn < > < > < > on/off the A and B zones. · Never set the temperature at 0°C and below when there are glass bottles in the cooler to prevent the freezing of the contents which may cause the bottles to break and lead to injury.
- Page 9 Powering Your Cooler Power the cooler by connecting to a wall outlet with the AC charging cable. Connect the cooler to a car's output port with the car charging cable. *Car Battery Protection Grades The cooler supports three levels of battery protection. To modify the level of battery protection, press , and then press to choose Protective Voltage, and confirm it by pressing .
- Page 10 Medium/High USB-C Note: The USB-C cable and charger are not included in the package. Power the cooler by connecting it to a wall outlet with the USB-C cable. Solar Panel (100W Max, 12V-30V) · This method of powering can only be used when the battery is in the cooler. ·...
- Page 11 Maintenance Best Practices · Turn off all power before cleaning to ensure safety. · Clean after disassembly and then install in reverse order. Do not use excessive force during disassembly to avoid damaging the components. · Use a soft cloth with a neutral detergent for wiping. Do not use scouring powder, benzene, hydrochloric acid, hot water, coarse brushes, abrasives, or hard objects to clean the cooler, as they may damage or corrode it.
-
Page 12: Specifications
Specifications Cell Capacity 288Wh Capacity 58 L / 61 qt Size 986 × 459 × 493 mm / 38.8 × 18.1 × 19.4" Battery Compartments Temperature Range -20°C to 20°C / -4°F to 68°F AC Input Power (Charging) 95W Max Solar Panel Input 12-30V 8.2A (100W Max)
Need help?
Do you have a question about the SOLIX EverFrost 2 and is the answer not in the manual?
Questions and answers