JoinTech Smart Miter JSM-48 Owner's Manual

Read this owner's manual before use and
retain it for future reference.
The Smart Miter will enable you to perform highly
accurate cuts on your table saw. The miter slot
runner bar can be adjusted to custom fit to eliminate
any side-to-side play, and the full swing fence with
fence extension and flip stop will facilitate a wide
variety of projects.
The auto-zero, auto-tracking feature will provide
accurate cut lengths at every angle setting from
–50 to + 50 degrees in ½ degree increments.
The dual fence scale will give accurate length
indications of both the inside and outside points
of finished mitered work piece, regardless of
width.
The sled is precision machined from premium-
quality, solid phenolic for durability and long life. Its
bottom side has three wide UHMW tape strips
running the full length of sled to create a smooth,
resistant-free movement over table saw surface.
Its miter bar is machined from solid Phenolic.
adjustment screws in miter bar provide means to
make a perfect slip-fit into your saw's miter slot.
The diverseness the Smart Miter offers will broaden
your ability to produce an endless list of highly
accurate angle cuts that cannot be achieved with
any miter gauge.
PARTS LIST:
Grip Handle
¼-20 x ¾" Hex bolt
Miter Bar, Solid Phenolic
Soc set screw, #10-32 x 3/8"
3/32" hex wrench
#10-32 x 1/2" machine screw
#10-32 flat nut
#10 flat washer
Fence Scale calibration block, 4"
45 degree wedge with thumbscrew
#8-32 x 2" ph. machine screw (Flip-stop lock)
Four
Description
Model JSM-48
Standard Saw
OWNER'S MANUAL
Quantity
1
1
1
4
1
4
4
4
1
1
1