Subscribe to Our Youtube Channel
Summary of Contents for Gardco INDCO HS Series
- Page 1 P A U L N G A R D N E R C O MP A N Y 9 1 0 4 G U I L F O R D R O A D , S U I T E H E MA I L G A R D C O @A L T A N A .
- Page 2 Series Disperser HS SERIES MIXERS OWNERS 1.5, 2 & 3 horsepower units MANUAL Contents: Page Safety, General & Installation Operation General Arrangement Drawings . Maintenance . Warranty Our products are guaranteed against Electric Motor Data & Troubleshooting defective materials and workmanship, we will Parts List repair or replace such items as may prove defective at our option.
- Page 3 Dispersers - Variable Speed Electric Model: Serial No.: Date: Order No.: INDCO, Inc. M-M-30117 mixer manual HS100-300 date: 6/22/05 2 of 13...
-
Page 4: Installation
Safety General Please follow the below safety precautions. Please read The HS-100/300 series 1.5 to 3 horsepower electric powered this complete manual before trying to operate your mixer. high-speed dispersers are designed for bench top use to Failure to follow these instructions could result in serious process batches up to five-gallons. -
Page 5: Operation
Operation Caution: • Never run mixer without an impeller. • Never run the impeller in open air. • Never run impeller outside a container. • Always stop and start the disperser in the lowest variable speed hand-wheel setting. In general the disperser is run at blade tip speeds of 2500 Electronic Speed Control: to 5000 feet per minute. - Page 6 Operation, continued Hydraulic Jack Lift, Mechanical Variable Speed Belt-Drive Hydraulic Jack Operation: Lifting: 1. Insert the handle onto the release valve and turn clockwise until the valve is firmly closed. 2. Place handle into jack handle sleeve “receptacle”. 3. Actuate the jack handle up and down to raise the impeller to the desired height. Lowering: 1.
- Page 7 Operation, continued Air Cylinder Lift, Mechanical Variable Speed Belt-Drive Air Cylinder Operation: • Air Valve ~ Cylinder speed control adjustment: lock-nut Before connecting your air supply ensure the lift control Air flow adjusting screw: valve is in the center (off) position. Connect your air supply - screw in until desired to the quick connector at the 3-position air valve.
-
Page 8: Maintenance
Maintenance Maintaining your mixer is not difficult if you follow these Mechanical Variable Speed Drive: guidelines: • Avoid using automotive chassis and other non- • Keep the mixer clean. interchangeable lubricants. Lubricated pulleys will stick • Check all wiring on a regular basis and repair as needed. or freeze if not lubricated properly. -
Page 9: Electrical Connections
Electric Motor Data, variable speed If your HS Series mixer has the electronic inverter duty variable speed, see enclosed Baldor SmartMotor® owners manual. Electric Motor Data, fixed speed General: Electrical Connections: Electric motors are wired to operate in a Clockwise rotation, when If your new mixer has not been supplied with a power cord viewed from top of mixer looking downward into the mixing assembly by INDCO, see information below and consult your... - Page 10 Electric Motor Data, fixed speed (continued) Operation: Condensation Drain Plugs: Ensure that voltage and frequency stamped on motor All explosion proof and some totally enclosed motors are nameplate corresponds with that of the power line. equipped with automatic drain plugs, they should be free of Check all connections to the motor with the wiring diagram.
- Page 11 Electric Motor - Troubleshooting Problem or Complaint Possible Cause Remedy Motor is NEW (or basically new) 1. Switch is bad, or switch could have been damaged in shipment. 1. Replace switch, cord, or both as necessary. and has a cord, plug, and switch Could also have a damaged cord (partially cut or torn, insulation on by INDCO.
- Page 12 Electric Motor - Troubleshooting (continued) Problem or Complaint Possible Cause Remedy Motor runs fine when no load is 1. If motor is new, see above under possible overload situation, or 1. Repair as mentioned previously, or examine customer applied. When loaded, it loses possible bad motor.
- Page 13 Parts List - HS Series Dispersers Air Cylinder Lift Hydraulic Jack Lift 404 405 INDCO, Inc. M-M-30117 mixer manual HS100-300 date: 6/22/05 12 of 13...
- Page 14 Parts List - HS Series Dispersers Item Description Part No. Qty. ELECTRIC MOTOR 100. 1.5 HP, TEFC, 115/230VAC - 1-phase MTR-1.5-56C-1-TEFC Cord, 14/3, with 3-prong plug (not shown) CPG-14/3 Switch, ON - OFF (not shown) SWT-DP-TOGGLE Switch guard (not shown) SWT-GUARD 100.
Need help?
Do you have a question about the INDCO HS Series and is the answer not in the manual?
Questions and answers