A&M SIMPLE Manual

Before first use

• It isrecommended to treat the external wooden surface of the jacuzzi with a weather-resistant wood impregnation product suitable for outdoor use.
• Place the jacuzzi on ahardened and leveled surface.
• Fill the tank up to a maximum of3/4 of its height.
• During heating,cover the jacuzzi with a lid to prevent heat loss.

Bathing

• Ensure that your health condition allows safe use of the jacuzzi.
• Do not use the jacuzzi while under the influence of alcohol, drugs, or strong medication.
• Make sure that using the jacuzzi does not pose a risk to you or others nearby.
• Never leave children unattended near the jacuzzi.
• For safety reasons, enjoy hot baths in the presence of other people.
• Do not leave sick, disabled individuals, or children unattended during bathing.

Hygiene

• Maintain water hygiene using widely available water care and disinfection products.
• Regularly replace the water depending on its current condition.

Operating instructions

• Do not allow water in the jacuzzi to freeze, as it may damage the basin, water system, and accessories. In low outdoor temperatures, use brine, keep the water heated, or completely empty the tank.
• During severe frost, if it is impossible to maintain water at a positive temperature, empty the tank and system to prevent freezing and damage.
• To completely remove water from the system at the final stage of emptying, turn on the aeration system for a few seconds to expel all water from the circuit.
• Running the pump without water for an extended time can damage it!
• Heat the water to a maximum of 40°C; higher temperatures can deform the liner, and bathing at higher temperatures is harmful to health.
• The heater is equipped with a flow switch that activates when water is flowing.

Controls

• The jacuzzi is equipped with 10 water-air jets controlled by a pneumatic button and a dial.
• Air is drawn into the jets from a suction valve located on the upper edge of the tub.
  The valve can be adjusted to increase or decrease the air (via the dial on the panel).
• The pneumatic button activates the water pump, turning on the hydromassage.
• The 3kW heater is located in the water circuit supplying the jets.To activate the heater: Set the temperature on the dial located directly on the heater and turn on the water pump.
• The water circuit is activated using the pneumatic button.
• The LED lighting switch is also located on the housing. Color changes occur with each subsequent press of the button