Related Manuals for VANTAGGIO V70-BEV-BG
Summary of Contents for VANTAGGIO V70-BEV-BG
- Page 1 The best of both worlds MODEL: V70-BEV-BG WINE & BEVERAGE CENTER Instruction Manual...
- Page 2 Disconnect the of non-hazardous bottled or canned products only. appliance from the main power. Thoroughly ventilate the room in which the appliance ➤ is located for several minutes. Notify Vantaggio customer service for next steps at ➤ vantaggiowinecellars.com.
-
Page 3: Installation Instructions
Allow 24 hours before switching on the wine cellar. Installation Instructions During this time we recommend that you leave the door open to clear any residual odors. WARNING - To avoid a hazard due to instability of ➤ the appliance, it must be fixed in accordance with BEFORE LOADING &... -
Page 4: Grounding Instructions
Your wine cellar is equipped with 4 adjustable feet Notes to facilitate easy leveling. We recommend that you tighten the back feet to the maximum and adjust This model is for both built-in and free-standing ➤ the front feet to level the beverage center. type. -
Page 5: Dimensional Drawings
INSTALLATION DRAWINGS FOR BUILT-IN WINE AND BEVERAGE CENTER: (UNDER BENCH OR IN COLUMN) FRONT VENTING WINE CELLARS ONLY. Note: The appliance must be positioned so that the plug is accessible after installation. DIMENSIONAL DRAWINGS: It is built-in model inside cabinet, the cabinet should come with good ventilation space and no backpane, otherwise it will affect the wine and beverage center functioning properly (installation drawings below). - Page 6 OPEN ANGLE SIZE DRAWINGS: MODEL: V70-BEV-BG 605mm =798mm...
- Page 7 RADIATOR SYSTEM DESCRIPTION: MODEL: V70-BEV-BG This model use side anti-dew tube and Independent cooling system: COMPRESSOR FAN OUT CONDENSER...
- Page 8 Turning on your Beverage Center Loading your Wine and Beverage Center Plug in and switch on the center by pressing on the power button for a few seconds. When you use the You may load your wine bottles in single or double wine and beverage center for the first time (or restart rows while taking note of the following: if you do not the wine and beverage center after having it shut off...
-
Page 9: Temperature Settings
Types of Regulation Temperature Settings Please note that depending on the loading and settings Important: The LED displays by default the actual chosen it takes about 24 hours for the wine and internal air temperature. beverage center to see the temperature stabilizing. The electrical board of all models comes with During this time the LED could move erratically. - Page 10 DISPLAY BOARD OPERATING INSTRUCTION: SINGLE WINDOW DISPLAY BOARD OPERATING INSTRUCTION: j Display Window: Display the measured temperature inside the wine and beverage center. k Cycle Button (Temperature control / Fahrenheit Celsius conversion) Each press, the temperature inside will drop 1ºC, until reduced to the lowest temperature, and then a return to the highest temperature.
- Page 11 WINE SERVING TEMPERATURE CHART: All wines mature at the same temperature, which is a constant temperature set between 12ºC to 14ºC. The chart below indicates the best temperatures to drink your wines. Champagne NV, Sparkling, Spumante Champagne Vintage Dry White Semillon, Sauvignon Blanc Dry White Gewürztraminer, Riesling, Pinot Grigio Dry White Chardonnay Sweet White Vintage: Sauternes...
- Page 12 Important Information Defrosting / Condensation about Temperature / Hygrometry / Ventilation Your wine and beverage center is designed with “auto-cycle” defrost system. During “off-cycle” the refrigerated surfaces of the wine and beverage center defrost automatically. Defrost water from the wine and beverage center storage compartment drains Your wine and beverage center has been designed automatically and part of it goes into a drainage...
-
Page 13: Adjustable Wooden Shelves
Adjustable Wooden Shelves Handle Installation Method 1. Take out handle from cabinet, then take out 2pcs screws from accessory bag. (Note: the screws of some models have been put on the door. If the door is made of all black glass, two white insulating gaskets shall be sleeved on the screw holes to prevent the metal screws from shatterring the glass.) -
Page 14: Power Failures
Ventilation frame Power Failures Installation Method In the event of a power interruption, all previous temperature settings are automatically preserved and it will revert to a preset temperature setting. (see preset chart) An few hours of power loss will not have a huge affect on the wine and beverage cooler’s internal temperature. -
Page 15: Troubleshooting Guide
Troubleshooting Guide Common problems may easily be solved, saving you the cost of a possible service call. Please read the instruction manual carefully and reference the troubleshooting guide chart below. Problem Possible Cause • Not plugged in. Wine and beverage center does not operate. •... -
Page 16: Standard Features
Standard Features: Compressor operated: R600a • Available in rated voltage/frequency (as per country’ requirements): 120V/60Hz • Automatic defrost • Humidity: 65% RH +/-10% RH • Black outer and inner finish • Internal light • Adjustable feet x 4 • Two layers glass door •... - Page 17 Before disposing of the appliance. 1. Disconnect the main plug from the main socket. 2. Cut off the main cable and discard it. Correct disposal of this product This symbol on the product, or on its packaging, indicates that this product may not be treated as household waste.
- Page 18 Toast to perfection with Vantaggio. 1-888-253-6807 info@vantaggiowinecellars.com...
Need help?
Do you have a question about the V70-BEV-BG and is the answer not in the manual?
Questions and answers