Related Manuals for Svantek SA 271
Summary of Contents for Svantek SA 271
- Page 1 USER MANUAL SA 271 OUTDOOR MICROPHONE KIT ASSEMBLY GUIDE Warsaw, 2020-08-21 Copyright © 2020 SVANTEK. Rev.3.00 All rights reserved.
-
Page 2: Spare Parts
SA 277 Assembly guide PART SET SA 271 kit: Tools: 1 - tube K - 3mm Allen key 2 - dummy microphone 3 - O-ring type gasket Spare parts: 4 - clamp (2 halves) O1 - O-ring type gasket Ø35x1 5 - upper cone O2 - O-ring type gasket Ø26x1... - Page 3 SA 277 Assembly guide O-ring gasket locations inside...
- Page 4 SA 277 Assembly guide Secure preamplifier (A) with the dummy microphone (2) and connect the cable (C). Pull tube (1) over the cable.
- Page 5 SA 277 Assembly guide III. Connect the clamp halves (4) to the connector and insert O-ring gasket (3) on the lightning signed place. Apply the upper, conical part (5) on the preamplifier. Do not use preamplifier without the dummy microphone. It can cause damage of the O-ring gasket inside the cone.
- Page 6 SA 277 Assembly guide Screw the tube on the cone by rotating the tube – so as to not twist the cable. Replace the dummy microphone (2) with the ½” microphone cartridge (B).
- Page 7 SA 277 Assembly guide VII. Calibrate the complete system using SVANTEK acoustic calibrator. VIII. Install the microphone protection tube (6). Use the Allen key (K) as a pin at protecting tube orifice.
- Page 8 SA 277 Assembly guide Mount windscreen (8) and the anti-bird spikes (7). Slide the desiccator (9) inside the tube.
- Page 9 SA 277 Assembly guide Place the cable in the slot and connect the bottom part (12) by three screws (10) with washers (11). Use the Allen key (K). XII. Mount the completed system on the dedicated tripod or pole. Use ¼” thread adapter (13) (if necessary) (see last note on next page).
- Page 10 Desiccator should be inspected at least every 2 weeks, and more often when used in conditions of high air humidity. Desiccator must be stored in a hermetic container when is not installed in SA 271 to prevent absorbing moisture unnecessarily.
Need help?
Do you have a question about the SA 271 and is the answer not in the manual?
Questions and answers