LiteOn LA180PM180 Installation Instructions Manual

CAUTION: This product is for indoor use only.
1. The maximum output ratings as shown on the label shall not be exceeded.
2. The socket-outlet shall be installed near the equipment and shall be easily accessible.
3. The equipment shall be used at maximum 40°C ambient temperature.
4. Do not open the equipment to reduce the risk of electrical shock. For safety reasons it is only allow to be opened
by qualified service personnel.
5. Equipment has to be protected from objects falling through or liquids dripping through the openings. This could
cause a fire or electrical shock.
6. Disconnect equipment from power supply before cleaning. Do not use any liquid or aerosol cleaner. Use only
moisture cloth.
7. Equipment should be placed on a reliable surface. A drop or fall could cause damages.
8. If the equipment is not used for long time, disconnect the equipment from power supply to avoid being damaged
by voltage peaks or lightning strike.
9. If one of the following situations arise, equipment has to be checked by qualified service personnel:
• Power cord or plug is damaged.
• Liquid has penetrated into the equipment.
• Equipment has been exposed to humidity.
• Equipment has been dropped and/or is damaged.
• Equipment has obvious sign of breakage.
• Equipment does not work well or you cannot get it working according to user's manual.
A certified power supply cord has to be used with this equipment. The relevant national installation and/or
10.
equipment regulations shall be considered. A certified power supply cord not lighter than ordinary polyvinyl
chloride flexible cord according to IEC 60227 (designation H02 VV-F or H02 VVH2-F) shall be used. The power
cord set shall have a power supply cord with conductors providing a cross-sectional area of 2X0.75mm
minimum.
Altitude = 5000M
11.
12.
SAFETY REQUIREMENTS
Mains Plug:
Use a 3-pin mains plug that is registered with the Safety Authority.
Flexible Cord:
Use a double insulated flexible cord that is certified* to the relevant IEC standards.
Appliance Connector:
Use an appliance connector certified* to IEC 320.
*certified by member of IECEE CB Scheme.
13. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for
disposal at least for free of charge.
Lite-On Technology Corporation
Manufacturer :
90, Chien I Road, Chung Ho, Taipei Hsien, 235 Taiwan
Address :
1/5
INSTALLATION INSTRUCTION MANUAL FOR
GENERAL-USE AC/DC ADAPTER
MODEL: LA180PM180 DELL
2