Summary of Contents for EPS Millenium 3
- Page 1 EPS Standalone Autovalve Manual Europe Pool Supplies BV TEL: +31 344 635 789 – INFO@EPSBV.EU – WWW.EPSBV.EU...
-
Page 2: Note On Environmental Protection
Warnings • This manual is intended for technically qualified personnel responsible for the installation, settings, and maintenance of the entire system. The manufacturer is not responsible for damages and/or malfunctions resulting from the intervention of unqualified personnel or from use contrary to this manual. •... -
Page 3: Table Of Contents
3.4 Manual operation ........................11 Introduction The Standalone Autovalve is specially designed to control the EPS Autovalve without an EPS dosing system. This manual demonstrates how to install and operate the system. The standalone Autovalve comes with a 3-meter power cable. -
Page 4: Installation
2 Installation 2.1 mounting the standalone unit. Make sure there is enough space beneath the respective unit so that the casing can still drop a few millimeters. How far the unit will drop to clear the screw head depends on the screw used. 288mm 15mm Max. -
Page 5: Connecting The Standalone Unit
2.2 Connecting the standalone unit. The following image and table for the connection. Only connect the power supply to 220-240V AC. 3 4 5 6 7 8 9 10 Number Description Red wire (Autovalve cable) Brown wire (Autovalve cable) Phase of the filter pump Neutral of the filter pump Blue wire (Autovalve cable) Pink wire (Autovalve cable) - Page 6 The black cable coming from the EPS Autovalve must be connected as follows: Number Description Brown wire to input 3 Blue wire to input 4 Europe Pool Supplies BV STANDALONE AUTOVALVE...
-
Page 7: Settings And Operation
1 to 59 minutes. The rinse duration is always 1 minute and 30 seconds. Automatic backwashing always occurs on Mondays at 12:00 PM . With the manual function, you can manually switch all positions of the EPS Autovalve. Additionally, in the manual menu, you can turn your 230V filter pump on or off. -
Page 8: Automatic Backwash
3.3 Automatic Backwash When setting up and using the automatic backwash function, there are several important points to consider: • Automatic backwashing always occurs on Mondays at 12:00. If the power supply of the controller is interrupted, all settings will be erased. •... - Page 9 2. Here, you can choose between Backwashing once a week or once every 2 weeks using the + and - buttons. Confirm by pressing the "OK" button again. 3. Now, you can select the number of minutes you want to backwash using the + and - buttons. To save these settings, press the "OK"...
- Page 10 6. On the day when automatic backwashing begins, you will see this symbol appear. Europe Pool Supplies BV STANDALONE AUTOVALVE...
-
Page 11: Manual Operation
2. Then, press the "OK" button to open the manual menu. Now, a list of the 6 positions of the EPS Autovalve and 1 position to switch the pump will appear. Use the arrow buttons to navigate through the menu. Press ESC to go back to the previous screen and OK to select a position. - Page 12 3. As an example, let's initiate a Rinse cycle. Choose the desired position and press the "OK" button. Now, a message will appear asking if you want to move to the selected position. Press OK to confirm and ESC to go back. Once confirmed, you cannot go back, and you must wait until the Autovalve reaches the selected position.
Need help?
Do you have a question about the Millenium 3 and is the answer not in the manual?
Questions and answers