EMP 13751 Installation Instructions

Yamaha YXZ Hard Coated Cab Back/Dust Stopper
Includes:
1. (1) Hard Coated Cab Back
Hardware Kit:
1. (7) Rubber Fast Strap
(11651)
2. (4) 1/8" x 12" Long,
Bubble Edge Trim
3. (2) 1/8" x 2" Long,
Bubble Edge Trim
4. (1) EMP® Logo Decal
Tools Needed:
1. Phillips Screwdriver
2. 7/16" Wrench
NOTE: Once the
protective film is
removed, this item
can not be returned.
Check the fitment and
make sure you will be
happy with this product
before removing the
film. There are no
exceptions.
www.ExtremeMetalProducts.com
EMP P/N - 13751
Fits: 2019 Yamaha YXZ
Installation Instructions:
Installation should be performed
by a certified technician.
Installation:
1. Peel back the protective film
around the slots and along the top
and bottom edges. Just enough to
install the rubber straps and edge
trim.
2. Using the screwdriver and wrench
install the rubber straps to the
polycarbonate. NOTE: The two
top straps will go on the inside/
front side and the remaining straps
will go on the outside/back side of
the polycarbonate.
DO NOT TIGHTEN YET.
3. Slide the edge trim over the top
and bottom as shown in the
picture.
4. Slide the partially assembled cab
back inside the buggy and against
the back of the cage.
5. Once you have it in the correct
location tighten the screws on the
Fast Straps.
6. Remove the protective film.
7. Enjoy your new EMP® product
and visit our website for
information on other accessories.