KD-310 Panel Operation Instruction ......... Advanced Programming ..........Cleaning Guidelines ............Care and Cleaning ............11-12 Recycling and Disposal ..........12-13 Product Specifications ............Thank you for purchasing an Espresso Machine by WPM. Please read this manual carefully before using.
• The heating element surface is subject to residual heat after use. If you have any concerns regarding the performance and use of your appliance, please visit www.wpm.hk or contact the Welhome Consumer Service Line. Ensure the above safety precautions are understood.
The Parts of KD-310 1. 2.5 litre water tank 8. Programmable control panel 2. Warming plate 9. Pressure gauge 3. LCD display, low water indicator & timer 10.Hot water control panel 4. Steam control dial 11.Hot water wand 5. Temperature sensing steam wand 12.Manual control 6.
Preliminary Steps Before First Start-up When using the machine for the first time, you must carry out these steps: 1. Rinse the components. 2. Remove the lid and take the water tank out. Remove the water tank panel. 3. Carefully rinse the tank 4.
Beverage Preparation 1. Coffee Brewing Use the provided filter basket for 2 cups of coffee. Necessary condition: There must be enough water in the tank – and the machine must be at the correct pressure and right working temperature Scalding hazard! Warning: Do these steps very carefully. 2.
Steam Dispensing General instructions Milk is a product that will turn sour easily, and its quality is affected by the temperature. When the milk carton is opened, to consume the product for theentire best-before-period, the milk must be kept at a temperature that does not exceed 5°C (41°F);...
Hot Water Dispensing Scalding hazard! Warning: Do these steps very carefully. Use the special insulated devices to move the water and steam wands. Place a container beneath the hot When the desired dose has been water tube and turn the knob reached, stop the hot water by counterclockwise.
Page 9
4. Fill tank: remind user to fill the 5. Check: when “CHECK” is flashing tank by flashing “NO WATER” on screen which means the steam when the water level is low in knob, hot water knob or manual water tank. handle may not return to off position.
Advanced Programming In standby mode, press “ ” button and get in to the setting mode. (sequence: group head water outlet temperature, steam flow rate, pre-infusion, cleaning limit, Reset). Keep pressing “ ” to choose the desired program setting. 1. Group head water outlet temperature: adjust the coffee thermoblock temperature (range: 86 / 88 / 90 / 92 / 94 / 96 / 98);...
Page 11
1 cup volume: adjust the 1 cup volume (LCD will display the time counting, but the volume will be determined by flow meter); press and hold “1 cup” button for 3 seconds then the machine will start brewing, when the coffee volume is enough, press again “1 cup”...
Cleaning Guideline Below is the cleaning procedure of Coffee Machines of KD-310. Please follow the Procedures to clean. Procedures Cleaning Reminder System Press the button ONCE, “CO CLEAN” will appear on the LED screen. Then, “CO CLEAN” will be press the button to clean the water shown by the machine circuit of the brewing head.
Care and Cleaning The coffee making process involves extracting brush to remove them. Also you can use oils out of coffee grinds to make espresso the cleaning pin which is supplied with coffee. Deposits of these oils build up over the espresso machine.
Steam wand Important: Never clean the steam wand with an abrasive pad as this will damage the Keeping the steam arm clean is essential steam wand. to ensure maximum efficiency of the steam Should the steam wand become blocked, function. A build up of caramelised/dried supplied with the espresso machine is a milk on the steam wand will impair the cleaning pin.
Need help?
Do you have a question about the WELHOME PRO KD-310 and is the answer not in the manual?
Questions and answers