Swimming pool chlorinator, swimming pool & spa purification system for use with rc-11 & rc-35/22 cells, only! (32 pages)
Summary of Contents for Aquacal Pool Pilot Professional
Page 1
2024-5690 2024-12-12 Imported to Canada by AquaCal AutoPilot, Inc. 2737 24 Ave North St Petersburg, FL 33713 1.727-823-5642 REGISTRATION NO. 26962 PEST CONTROL PRODUCTS ACT Pool Pilot Professional MODEL 7200 Chlorine Generating Device A Minimum of 1 ppm of available...
Page 2
READ THE LABEL AND THIS MANUAL BEFORE INSTALLING & OPERATING PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE PRECAUTIONS Do not use this device with bromide products. AquaCal AutoPilot, Inc. • 2737 24th St North. • St Petersburg • FL, USA • 33713 727.823.5642 www.autopilot.com...
Section 1a – GENERAL PRODUCT INFORMATION Table of Contents Pool Pilot Professional (MODEL 7200) by AquaCal AutoPilot, Inc.. Section 1 GENERAL INFORMATION Table of Contents ......................1 Product Information and Contact Numbers ..............2 Important Safety Instructions ..................3 Technical Specifications ....................4 Section 2 INSTALLATION Main Components ..........................
Unclassified / Non classifié Section 1b – GENERAL PRODUCT INFORMATION Pool Pilot Professional Model 7200 by AquaCal AutoPilot, Inc. Record The Following Information Installer: Date of installation: Project Name: Professional (Model 7200) Power Supply: Serial Number: # A 998(CC-30) Cell(s)
READ AND FOLLOW ALL INSTRUCTIONS INSTALLATION AND EQUIPMENT RELATED Installation of Pool Pilot Professional ( MODEL 7200): When installing and using your Power Supply, basic safety precautions must always be followed, including the following: Follow all aspects of the local and National Electrical Code(s) when installing your Power Supply.
Unclassified / Non classifié Section 1d – GENERAL PRODUCT INFORMATION Technical Specifications Pool Pilot Professional (Model 7200) POWER SUPPLY CHLORINE CELL MODEL 998 (CC-30) Power In: Housing: Molded High-Impact PVC 110VAC/15A, 220 VAC/7.5A, 50/60 Hz Power Out: To each 998 (CC-30) Cell – 11 Amps (DC) Length: 42.5cm (17”)
Labeling and Markings: To avoid mismatching or crossing cell terminals, ensure that each cell and cell cord is appropriately labeled with markings to identify them. AquaCal AutoPilot Inc. recommends using a marking system of A-1, A-2, A-3, etc… for each cell and cell cord, then marking the Power Supply with “PS A”...
Unclassified / Non classifié Section 2b – INSTALLTION ORP/PPM Connections and Fuse Locations REMOTE CONNECTIONS (ORP/PPM Controls) When an ORP/PPM chemical controller is interfaced to your Power Supply, your Output Level Setting should be on 100% (Maximum) Output and will be controlled by the ORP/PPM controller. The ORP/PPM controller wires will attach to the 2-circuit terminal marked for ORP/PPM, located at the top of the electrical access box.
Unclassified / Non classifié Key Features and Power Supply Section 3a – OPERATION Key Features Your Power Supply is equipped with several key features and very few controls to make it easy for you to maintain and operate. After the initial start-up period, your pool will be ready for your Power Supply to take over so you can sit back and relax! Self-Test Cycle: During the first 30 seconds of start-up, your Power Supply will perform a series of self-diagnostic tests.
At this point, no chlorine will be generated until the RED Light status is corrected. Check the TROUBLESHOOTING section, on page 11 or contact your dealer or AquaCal AutoPilot, Inc. for further assistance.
For specifics and how much to add, please read and follow package instructions. CALCIUM HARDNESS AND TOTAL ALKALINITY: Your Pool Pilot Professional Model 7200 system provides 100% pure sodium hypochlorite and does not affect the calcium hardness or total alkalinity levels. When you start up and maintain your pool with proper water chemistry, it stays balanced much easier, until influenced by adding other ancillary chemicals or “out of balance”...
Unclassified / Non classifié SALT RESIDUAL: Your Power Supply works most efficiently with salt levels between the above-recommended ranges. Low salt will cause premature deterioration on the Cell blades. It is important that a minimum salt level of 2800 ppm be maintained at all times.
B) Debris in the Cell. B) Inspect the Cell monthly and clean debris if needed. C) Excessive chlorine demand. C) Consult your dealer or AquaCal AutoPilot, Inc. White Flakes in the Water. A) This occurs when excessive calcium hardness is A) Visually inspect Cell(s) for scale build-up and clean the cell as present.
Unclassified / Non classifié Section 4b – TROUBLE SHOOTING AND SERVICING SERVICING NOTE: All repairs and troubleshooting should be performed by a qualified technician. Accessing the Power Circuit Boards to replace the Board or Fuses: CAUTION: BEFORE SERVICING, TURN OFF ALL POWER TO THE POWER SUPPLY, AT THE MAIN PANEL CIRCUIT BREAKER! The front cover plate is held on using four (4) screws.
Unclassified / Non classifié Section 4c – TROUBLE SHOOTING AND SERVICING To obtain service for your Professional (Model 7200) system, contact the Authorized Dealer/Service Centre listed below, or: AquaCal AutoPilot, Inc. 2773 24th St North St Petersburg• FL • USA • 33713 Téléphone : 727.823.5642 •...
Need help?
Do you have a question about the Pool Pilot Professional and is the answer not in the manual?
Questions and answers