Download Print this page

Unior 1693EL Calibration Procedure

Electric bike repair stand 2.0

Hide thumbs Also See for 1693EL:

Download this manual

Scale calibration is required, if the following spare parts are replaced:

1. Middle assembly

2. Chain assembly

3. Scale electronics

4. Upper assembly

1. Drive the clamping master arm to a height of 110 cm

2. Hold the button

press the button

3. Calibration is performed in 5 steps



First, ensure there is no weight on the master arm and confirm zero weight by holding the

STOP button pressed for about 3 seconds until the beep sound and change of numbers on

display to 05 on upper display and 10 on lower display

Electric bike repair stand 2.0

SCALE CALIBRATION PROCEDURE

on the control panel for about 1 second to enter the settings menu and

once again to enter calibration page, as shown on picture below.

Need help?

Do you have a question about the 1693EL and is the answer not in the manual?

Page 1 Electric bike repair stand 2.0 SCALE CALIBRATION PROCEDURE Scale calibration is required, if the following spare parts are replaced: 1. Middle assembly 2. Chain assembly 3. Scale electronics 4. Upper assembly 1. Drive the clamping master arm to a height of 110 cm 2.
Page 2  the second step requires to hang the weight between 5 kg and 10 kg on the master arm. By rotating the STOP button set the value on middle display that is equal to real weight that is hanged on master arm. Then confirm this step by holding the STOP button pressed again for about 3 seconds (in our case, we hung 7 kg on the master arm and set the number 7 on the control panel as shown on picture below.
Page 3  In third, last step, it requires to hang on the weight in the range between 60 kg and 70 kg, as indicated by value 60 on upper display an 70 on lower display. Repeat the process of setting the middle-display number to match the real weight on the master arm. Then confirm this step by holding the STOP button pressed again for about 3 seconds (in our case, we hanged 67 kg on the master arm and set the number 67 on the control panel as shown on picture below.