GENERAL INSTRUCTIONS UNPACKING: Thank you for purchasing PRORECK products. Each product has been thoroughly tested and shipped in perfect operating condition. Check carefully that the packaging where it is sent is not damaged, this may have occurred during transport. If this carton appears damaged, carefully inspect your kit for any damage and ensure that all accessories necessary to operate the unit have arrived intact.
Page 3
As with all stage sound boxes, the sound will remain mono even when two sound boxes are connected. Getting Started Guide The PRORECK series loudspeakers are easy to set up and use, here's how to get started with your systems, before starting the system must be turned off.
Page 4
Amplification and process The power stage of the entire PRORECK series is based on class AB amplifiers, this guarantees the best use of energy, delivering great sound quality while adding minimal weight to the box.
Page 5
BACK PANEL FUNCTONS 1. Selector signal input for MP3/Bluetooth/FM. 2. Antenna receiver 3. MUSIC Volume Settings. 4. MUSIC TREBLE Volume Settings. Control the volume of Bluetooth, Line in, MP3, and FM. 5. MUSIC BASS Volume Settings. 6. Mic Treble Settings. 7.
FREEDOM10 Specifications FREEDOM10 2way 10”portable speaker Class AB rms 120w rms Impedance 4 Ohm Frequency range 35-20K Hz Spl (1W/1m) 96 dB S/N ratio >85 dB Woofer/ Coil 10”(250 mm) Voice coil / Magnet 38mm/40 0z Tweeter diaphragm 1" titanium (25.4 mm) BT VERSION V5.0/ TWS BT ERP...
Page 7
General The device does not work, the POWER LED is not lit. • The amplifier is not switched on. - Check the position of the rocker switch on the back. • The power cord is not connected properly. - Check the correct connection of the power cord at the device and the wall socket. •...
Page 8
Visit our website : www.audioproreck.com Feel free to contact us via sales-1@proreck.com...
Need help?
Do you have a question about the FREEDOM 10 and is the answer not in the manual?
Questions and answers