Bass Pro Shops 3896667 Assembly Instructions

Congratulations on your purchase. Your Bass Pro Shops tent is very easy to pitch.
Follow these instructions to pitch your tent quickly safely and easily.
We strongly advise you to assemble your new tent once before going
camping to become familiar.
1 Assemble the tent
A) Spread the tent flat on the ground, floor side down. Secure all four corners
using the tent stakes.
B) Slide the black fiberglass roof pole with gray tape through the middle pole
sleeve located on the roof of tent. Slide the remaining fiberglass roof poles into
the other two pole sleeves.
C) Insert all the roof pole ends into the elbow connectors attached to the tent roof.
B
A
C
D) Insert one end of the steel leg pole into the elbow connector attached to the
tent roof. Insert the other end of the steel leg pole into the pin located at the
base of the tent. Repeat for all steel leg poles.
Note: The two steel leg poles with metal D-ring are located in the middle of
the front side and back side of the tent.
E) Attach all G hooks to the leg poles to secure and shape the tent.
F) Make sure the base of the tent is fully spread out and stake out the rest of the
tent, adjusting stakes as necessary for proper tension. When set up correctly,
the floor should be flat with limited wrinkles on the inside of the tent.
ASSEMBLY INSTRUCTIONS
#3896667 10P CABIN TENT
D
D
E
2 Attach the rainfly
A) Lay out the rainfly. Spread and place the rainfly over the top of the tent body.
B) Attach the S hooks on the rainfly to the end of the tent poles.
Note: Attach the S hooks in the middle of the rainfly to the metal D-rings on
the middle steel leg poles.
C) Secure the rainfly to the tent poles with the velcro attachments that are
sewn to the underside of the rainfly.
C
D
B
3 Stake the tent
Stake out guy ropes (D) away from the tent with ropes at roughly a 45°angle
to the ground. Using the plastic sliders to adjust the tension and make sure
the tent is staked well.
4 Add accessories
Attach the gear loft and divider if needed.
Things you should know
1) Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside your tent. It is NOT
LEAKAGE through the tent fabric. It can be minimized by removing
wet clothing from you tent and by providing good ventilation
through the tent.
2) Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
3) Stakes should be removed by pulling on the stake itself. Never pull
on the tent fabric or tent stake loop to remove stake.
4) Tent poles should not be left telescoped together during storage.
5) Seam sealer has not been provided with your tent. For additional
protection we recommend seam sealing your tent prior to camping.
Seam sealer may be purchased at your Bass Pro Shop or online.
6) Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage
material and/or cause it to become discolored.
7) Take down your tent in the reverse order and keep fold the same length
as the tent bag.
Warning: Keep all flame and heat sources away from this tent
fabric. This tent meets the flammability requirements of CPAI-
84. The fabric will burn if left in continuous contact with any
flame source. The application of any foreign substance to the
tent fabric may render the flame-resistant properties
ineffective.