Advertisement
Advertisement
Table of Contents
Summary of Contents for Waters Automation Portal+
- Page 1 USER MANUAL Automation Portal+ ©2024 Waters Corporation...
-
Page 2: Safety Instructions
Safety instructions • The user must maintain a distance of at least 20 cm from the product (WiFi antenna) during installation or operation. • The device is intended for indoor use only. • If the device is used in a manner not specified by the manufacturer, the protection provided by the device may be impaired. - Page 3 Waters. Waters assumes no responsibility for any inaccuracies that may be contained in this User Manual. Waters makes no commitment to update or keep current the information in this User Manual, and reserves the right to make improvements to this User Manual or to the products described herein at any time without notice.
-
Page 4: Product Overview
Product overview Automation Portal+ Automation Portal+ bridge (with mounting bracket) RS232 to USB cable LC, LC/MS instrument; Sample Manager component (sold separately) Automation Portal+ frame Automation Portal+ Automation Portal+ bridge Rear view (connectors face) LED indicator Connectors Power Ethernet USB port Built-in wireless for cable socket... -
Page 5: Getting Started
Getting started A. Installation of the Automation Portal+ bridge Brackets are provided to help you place the Bridge on any surface of your choice. Remove the sticker protection and attach the Automation Portal+ bridge using the Connectors velcro strips We recommend placing the bridge on the side of the LC, LC/MS instrument above the Automation Portal with the cable connectors facing back and the... - Page 6 Contact your Waters representative. Ordering info: Microplate Gripper (Tool), Waters p/n: 186009776 Ordering info: Andrew+ Active Rotating System (Tool), Waters p/n: 186011277 Ordering info: Andrew+ BencHub (Tool), Waters p/n: 186011278 When used with the Andrew+ Pipetting Robot, the Automation Portal+ is always...
- Page 7 C. Installation of the Automation Portal+ frame (only for use with Andrew+) This frame must be installed to make the device compatible with the Andrew+ robot. Place the frame over the Automation Portal and ensure it is properly aligned...
- Page 8 D. Connection to OneLab If you do not have a OneLab account, please create one by going to: Before https://onelab.andrewalliance.com/signup you begin Wait for the LED indicator to Plug the Automation Portal+ turn blue and blink. bridge into a power source. The device will automatically start up.
- Page 9 Feel free to contact the Waters Chat with our support team Send us an email at support team directly in OneLab aa_support@waters.com We reply within one business day Operations Design your protocol Our drag-n-drop editor makes it easy to design a precise and complete protocol with all you need to run your experiment perfectly.
-
Page 10: Technical Data
Technical data Automation Portal+ Automation Portal+ Bridge ANSI/SLAS 4-2004 R2012 Sample plate Control compatibility connectivity 80% at 37°C Tray sensors IR LED emitter-sensor pair (sensing dis- Relative humidity tance up to 36 inches), non-apertured Maximum 2000 m USB-capable via one of the DB9 connectors PC control operating altitude Flash technology, upgradable via PC (USB) - Page 11 Canadian ICES-003. RoHS 3 (EU) 2015/863 Andrew Alliance S.A. Waters Corp Chemin Grenet 21 34 Maple Street 1214 Vernier (Geneve) Milford, MA 01757 Switzerland Phone: +41 22 518 0357 Phone: +1-508-478-2000 aa_contact@waters.com Part number: XXXXXXX version 00 | ©2024 Waters Corporation...
Need help?
Do you have a question about the Automation Portal+ and is the answer not in the manual?
Questions and answers