Ozobot Bit+ User Manual page 5

Calibrate Bit
How Do I Calibrate?
Draw a black circle, slightly bigger
Fill with
than your bot. Place Bit+ on it.
Black Marker
Press and hold the Bit+ Go Button
for 3 seconds (or until its top LED
flashes white), then release.
Bit+ will move outside the circle,
and blink green when calibrated. If Bit+
blinks red, start over from Step 1.
2 sec.
Step 1 Step 2 Step 3 Done!
When to Calibrate?
Calibration helps improve Bit+ code and line
reading accuracy. It is important to calibrate
when you change surfaces or screen types.
When in doubt, calibrate!
For tips on how and when to calibrate, please
go to ozobot.com/support/calibration
©Ozo Edu., Inc | Rev. 3-23 4