Remaining Running Time Display; Timer Programming; End Of Programme; Switching Off Automatically After The End Of The Programme - PITSOS DGS5512 - annexe 3 Manual

Hide thumbs Also See for DGS5512 - annexe 3:
Table of Contents

Advertisement

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display H.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).

Timer programming *

* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
– Close the door.
– Switch on ON/OFF switch (.
– Press button P until the digital
display H jumps to :
– Press button P until the displayed
time corresponds with your
requirements.
– Press START button @, timer
programming is activated.
– To delete the preselected starting time,
press the button P until
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value :
is indicated on the numerical
display H.
Switching off automatically after
the end of the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from :
:
:
:
– Close the door.
– Switch on ON/OFF switch (.
– Press and hold down the START
.
– Rotate programme selector 8
– Release button.
To change the setting:
is
– Rotate programme selector 8 until
– Press START button @.

Switching off the appliance

Short time after the end of the programme:
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
– Remove the utensils when they have
to :
.
Appliance does not switch off
automatically
Off after 1 min
Off after 120 min
button @.
until : ... s indicated on the digital
display H.
The factory set value :
digital display H.
the required value is indicated on the
digital display H.
The set value is saved.
Stop fitted).
cooled down.
en
is lit on the
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs5518 - annexe 3Dis5505 - annexe 3Dgs5512 3

Table of Contents