1. Manuals
  2. Brands
  3. Frosty Manuals
  4. Beverage Dispenser
  5. B-Cube
  6. Operator's manual

Frosty B-Cube Operator's Manual

Hide thumbs

Advertisement

Table of Contents

B-Cube
OPERATOR'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B-Cube and is the answer not in the manual?

Questions and answers

Summary of Contents for Frosty B-Cube

  • Page 1 B-Cube OPERATOR’S MANUAL...

  • Page 2: Description Of Controls

    EN GLIS H B-Cube crushed ice, dilute the concentrate further (about listed below (see figure 1). 20%). If using natural products (such as lemon or orange juice or coffee), dissolve 150-200 grams of sugar in each litre of the product.
  • Page 3 appears on the display. In this mode, the mixer window G). rotates but cooling is not enabled. This function is useful during rinsing, washing and sanitisation of the machine to prevent cooling of the product in the container. Press any key to exit cleaning mode at any time.

  • Page 4: Cleaning And Sanitizing Procedures

    EN GLIS H B-Cube situated in the vicinity of the dispenser and, front (see figure 4). specifically, near the gridded panels. Also make sure the air flow is not obstructed by the closeness of walls, boxes or other items. Leave a clearance of at least 15 cm all around the dispenser.
  • Page 5 (see figure 6). position (see figure 7). figure 5 figure 7 Disassemble the tap in the order shown (see figure 8). figure 6 Remove the seal of the container from its figure 8 Remove the drip tray and empty it.
  • Page 6 EN GLIS H B-Cube 7. 3. 2 DISMANTLING THE 7. 3. 3 CLEANING RECOVER Click open the two parts. (see figure 9). ATTENTION Before any disassembly and/or cleaning procedure make sure that the dispenser is disconnected from its power source.
  • Page 7 distributor is put back into operation with a groove. Click the two parts together. (see figure 12). new product. Wash hands with a suitable antibacterial soap. Prepare at least two gallons of a warm (45- 60 °C 120-140 °F) sanitizing solution (100 PPM available chlorine concentration or 1 spoon of sodium hypoclorite diluted with 2 litres of water) according to your local Health Codes and...

  • Page 8: In-Place Sanitization

    EN GLIS H B-Cube 14). Assemble the container and push it towards the back wall, making sure that it fits completely on the seal and that its lower coupling engages in the protruding part of the drip tray (see figure 17).

  • Page 9: Maintenance (To Be Carried Out By Qualified Service Personnel Only)

    rear of the machine (see figure 19). original spare parts from the manufacturer. ATTENTION Condenser fins very sharp. extreme caution when cleaning. Every month: check that the hexagonal joint gasket is not worn. If it is, replace the joint itself with an original spare part from the manufacturer (see figure 18).
  • Page 10 Frosty International B.V. Papierbaan 2-A 9672 BH Winschoten...

Table of Contents