Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Evolve WH30
- Page 1 Natural Gas Water Heater User manual and installation instructions...
- Page 3 WARNING This manual contains data and information for both the user and the installer. The user should look at the following chapters in particular: General warnings and safety, Flue gas device, Control panel. Please keep these instructions safe near the unit or gas meter for future use. DANGER: Instructions marked with this symbol must be observed to prevent me- chanical or generic accidents (e.g.
-
Page 4: General Warnings
GENERAL WARNINGS The instructions manual forms an integral part of the product and therefore must be carefully re- tained and always kept with the unit; if lost or damaged, a copy of these may be downloaded from the manufacturers web site www.evolvebathrooms.co.uk Installation of the unit and any other service or maintenance operation must be carried out by a Gas Safe registered installer. -
Page 5: Table Of Contents
TABLE OF CONTENTS 1. Important Information 2.1 Technical Data 3. Description of Unit 3.1 Parts Name 3.2. Electrical Digram 3.3 WH30 Dimension 4. Display Information 4.1 Display Content Instruction 5. User Instructions 5.1 Preparation before ignition 5.2 Temperature Setting 5.3 Ingition & Water outlet 5.4 Attention... -
Page 6: Important Information
1. IMPORTANT INFORMATON 1.1 FEATURES AND BENEFITS Energy saving Micro-computer intelligent control system This product has advanced technologies The core component of the gas water heater called Strengthened Combustion and Forced is a micro computer intelligent control system, Combustion. which is one of today’s most advanced mecha- These features aim to make the best use of tronic technology. -
Page 7: Technical Data
2. SPECIFICATIONS 2.1 Technical Data Name Domestic Gas Instantaneous Water Heater WH30(JSG16ST-S21) Model Nominal Heat Input(Hi) 30kW Nominal Heat Output 27.4kW Minimun Heat Input 9.5kW Minimun Heat Output 8.7kW Max Flow Rate(rise 25 ) 16L/min Appliance Type C13,C33 Gas Type... -
Page 8: Description Of Unit
3. DESCRIPTION OF UNIT 3.1 Parts Name Flue Duct Connector Front Cover Power Plug Display & Control Panel Cold Water Inlet Hot Water Outlet Safety Valve Gas Inlet Figure 3.1 (The dimension information is for reference only. Please refer to the actual product.) - 8 -... -
Page 9: Electrical Digram
3. DESCRIPTION OF UNIT 3.2 Electrical Diagram Figure 3.2... -
Page 10: Wh30 Dimension
3. DESCRIPTION OF UNIT 3.3 WH30 Dimenstion WH30 Model JSG16ST-S21 Hot water outlet 1/2" Gas inlet 1/2" Cold water inlet 1/2" Cold water inlet lter Safety valve discharge Figure 3. 3 All dimensions are in mm. (The dimension information is for reference only. Please refer to the actual product.) -
Page 11: Display Information
4. DISPLAY INFORMATION 4.1 Display Content Instruction Fan indicates Flame feedback indicates Dynamic display When the water heater is when fan operation. working, the ame signal feedback dynamic display. Working mode indicates Show the current water Inlet water ow instruction heater working mode. -
Page 12: User Instructions
5. USER INSTRUCTIONS increase the temperature before turning on Preparation before ignition again. • Make sure that the gas used is in accordance When a water outlet is open, but the switch with the gas stipulated on the data label. stays in the OFF position, the water heater •... -
Page 13: User Function Mode
5. USER INSTRUCTIONS user needs in the standby mode press the fu- Use function mode nction key again to exit the power saving mode. In standby mode (ie, no water status), press the function (@) key, you can select "Auto", "Eco", "normal”... -
Page 14: Check The Cumulative Amount Of Gas And Water
5. USER INSTRUCTIONS Check the cumulative amount of SAFETY CAUTIONS gas and water Prevention of freezing The @ button can inquire about the cumula- Drain the residual water inside the heater to tive water and gas consumption. prevent freezing after every use when the en- Click the @ key to query cumulative amount of vironment temperature is near or under 0°C, water usage, press @ key again to display the... -
Page 15: Gas Accident Prevention
5. USER INSTRUCTIONS Gas accident prevention • If the ame goes unsteady, stop using the wa- • Check if the burner is out after use and do not ter heater and contact your quali ed gas safe forget to turn o the gas valve and power if the registered installer or service engineer for re- bumer fails to extinguish. -
Page 16: Fire Prevention
5. USER INSTRUCTIONS 5.11 Carbon Monoxide toxicosis preven- 5.10 Fire prevention tion • Do not leave the water heater unattended • This product must exhaust the waste gas out- whilst in operation. doors so the duct must be connected to •... -
Page 17: Installaion
6. INSTALLATION 6.1 INSTALLATION • The gas water heater installed in a suitably ventilated room, in accordance with the reg ulations in force. Contact your local gas safe registered install- er who must also be to work on gas • The of the heater cannot be connected water heaters (users are recommended not to (Figure 6.3-2) -
Page 18: Installation Method
6. INSTALLATION • The gas water heater should be kept away between the gas water heater and other from combustible materials with the dis- electric equipment should be more than tance shown in Figure 6.3-4 at least. 400 mm. • The power socket must have a reliable earth Combustible materials wire to improve safety. -
Page 19: Installation Of Water And Gas Pipes
6. INSTALLATION heater reaches the rated heat input, the gas pressure must reach the rated heat input in the technological parameter form. Evolve WH30 Figure 6.5 Figure 6.4-2 • Gas inlet 1. Before connecting the gas supply, check the rating plate on the right side of the... - Page 20 6. INSTALLATION let is on your left. Although water piping Please follow the below requirements during the throughout your structure may be other than copper, we recommend that copper piping be used for at least 0.92 m before referring to Figure 6.6-1 about the installation and after the heater.
- Page 21 6. INSTALLATION Flue gas exhaust duct lengths Flue Duct Installation of Forced Exhaust & Air- Maximum Extension Pipes Supply Type Gas Water Heater(C1 ,C type). Exhaust-air(m) Type diameter This product is a Forced Exhaust & Air-Supply (mm) Type gas water heater, it can be used before exhausting the waste gas to the outdoor ac- cording to the strictest requirements.
- Page 22 6. INSTALLATION Type of air suction/ ue gas exhaust ducting Combustion air intake from outside Flue gas exhaust and air suction duct through external wall in the same range of pressure Flue gas exhaust and air suction duct from outside with roof terminal in the same range of pressure...
-
Page 23: Conversation Instructions
6. INSTALLATION Conversion instructions Evolve UK supply this water heater pre-set as a Natural Gas. Please ensure you have the correct model for your requirements. EVOLVE WH30 Figure 6.8-1 Figure 6.8-2 - 23 -... -
Page 24: Technical Instruction
INSTALLATION 6.9 Technical instruction Step 1 1. Scr ront panel and disconnect the display and control unit Open front cover terminal. Step 2 1. Scr Replace gas tube 2. Change to the matched gas ejector tube assembly. assembly Note: It's necessary to examine the air tightness after change, to (Figure 6.8-1) check the seal ring on the gas control system installed well to prevent gas leakage. - Page 25 INSTALLATION Step 4 1. After adjusting the volume and gas type, scr condary Secondary pressure screw on the gas control system 3 .And connect the second- pressure ary port and U type barometer with rubber pipe. adjustment 2. After the system is switched on and it combusts normally, press Up (Figure 5.16) and Down keys together for 5s.
-
Page 26: Volume Parameter Settings
Displayed Symbol Parameter Parameter Description 6.12 Gas pressure at the burner Displayed Symbol Parameter Model WH30 (JSG16ST-S21) 6.13 Gas type setting Model Gas type 950 ± 20 Pa 250 ± 10 Pa 1080 ± 20 Pa 250 ± 10 Pa WH30 1250 ±... -
Page 27: Maintenance
7.MAINTENANCE 7.1 MAINTENANCE or can not be ignited, please choose the suitable shower function. • The residual water in the heater may be fro - • The appliances should be checked and main- zen in the winter, this is bad for the heater, tained periodically by a competent person. -
Page 28: Trouble-Shooting Guidance
7. MAINTENANCE 7.3 Trouble-shooting guidance Errors Solutions Causes Turn on the main gas valve or Main gas valv check you have gas supply to • another appliance Main gas valve half on Turn on the main gas valve fully • •... -
Page 29: Explanation Of The Error Codes
7. MAINTENANCE 7.4 Explanation of the Error Codes If during operation the water heaters display shows a fault code, then please follow the below actions. Fault code will be when there is a fault. On such occasions, please turn the hot water outlet and then turn on or turn on the monitor, and then turn back on the outlet valve and try a hot water outlet once or twice. -
Page 30: Packaging And Accesories
8. PACKAGING AND ACCESSORIES Descrip Expansion rubber plug Moun t - f 4 pcs 1 set Flue duct C13 type - 30 -... -
Page 31: Gas Water Heater Disposal And Recycling
9. GAS WATER HEATER DISPOSAL AND RECYCLING 9.1 GAS WATER HEATER DISPOSAL AND RECYCLING The Gas Water Heater and any accessories must be disposed of correctly, separating the di erent materials for recycling where possible. The installer must dispose of the packaging used to transport the Gas Water Heater Recycle and dispose of the Gas Water Heater and any accessories in line with the regulations in force. -
Page 32: Warranty Certificate
WARRANTY CERTIFICATE - 32 -... -
Page 33: Warranty Conditions
Evolve is not liable for any costs attributable to these actions. Evolve reserve the right to charge in full for parts and labour for defect any fault that has occurred which is not attributable to a manufacturing defect of the Gas Water Heater or if access has been denied or not available following an agreed appointment. - Page 34 Benchmark Commissioning & Warranty Validation Service Record It is a requirement that the c is installed and commissioned to the manufacturers’ instructions and the data fields on the commissioning checklist completed in full. To instigate the Gas Water Heater warranty the Gas Water Heater needs to be registered with the manufacturer within one month of the installation.
- Page 35 GAS FIRED CONTINUOUS FLOW WATER HEATER COMMISSIONING CHECKLIST This Commissioning Checklist is to be completed in full by the competent person who commissioned the water heater as a means of demonstrating compliance with the appropriate Building Regulations and then handed to the customer to keep for future reference Failure to install and commission according to the manufacturer’s instructions and complete this Benchmark Commissioning Checklist will invalidate the warranty.
- Page 36 SERVICE RECORD It is recommended that your heating system is serviced regularly and that the appropriate Service Interval Record is completed. Service Provider ’ Before completing the appropriate Service Interval Record below, please ensure you have carried out the service as described in the manufacturer’s ’...
- Page 37 s a m ° Sales & Enquiries 01254 427 840 sales@yasupplies.co.uk www.evolvebathrooms.co.uk Unit 1, fort street, BB1 5DP Blackburn...
Need help?
Do you have a question about the WH30 and is the answer not in the manual?
Questions and answers