Download Print this page

Futureguard NuImage Awnings 3700 Series Assembly Instructions

Fabric window awning with sides

Advertisement

Quick Links

www.nuimageawnings.com
Series 3700
Fabric Window Awning with Sides
Read instructions carefully prior to assembly and installation.
mounting bar
top trim
(pre-attached on
the underside of
the awning)
fabric awning
Series 3700 Parts Check List:
Fabric Awning
Top Trim (attached)
Front Trim (attached)
*QUANTITIES & SIZE OF PARTS MAY VARY BY AWNING SIZE AND MODEL SERIES
Actual Size - End Views of Awning parts for easy reference and assembly:
Mounting Bar
Required Tools:
1
2
3
Phillips, Regular &
" Hex Head
1
4
Screwdrivers or Drill Bits
camel back wall
brackets
support arms
Edge Rafters (2)
Center Rafter(s)*
Mounting Bar
Top Trim
Power Drill
edge rafters
front trim
(pre-attached on the
underside of the awning)
-
anti
rattle bushings
(one for each end of both arms)
Support Arms*
Camel Back Wall Brackets*
Machine Screws (its tip is flat)*
Front Trim
Level
Tape Measure
Series 3700 with Sides
camel back wall brackets
(pre-attached to the outside,
Front Trim ends of the Edge Rafters —
see instructions)
center rafter ( s )
(4)
Small Screws*
Large Screws*
Anti-Rattle Bushings (4)
Edge & Center Rafter
Silicone Caulk

Advertisement

loading
Need help?

Need help?

Do you have a question about the NuImage Awnings 3700 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Futureguard NuImage Awnings 3700 Series

  • Page 1 www.nuimageawnings.com Series 3700 Fabric Window Awning with Sides Read instructions carefully prior to assembly and installation. Series 3700 with Sides mounting bar edge rafters camel back wall brackets (pre-attached to the outside, Front Trim ends of the Edge Rafters — top trim see instructions) (pre-attached on...
  • Page 2 Assembly Instructions Series 3700 Fabric Window Awning with Sides Series 3700 Fabric Window Awning comes packaged in two separate plastic FIG. 1 bags: Bag one contains the hardware and instructions; bag two contains the awning with three frame pieces, a Mounting Bar, Top Trim and Front Trim. For your convenience, the Front Trim and Top Trim frame parts are already attached Hardware Pack to the awning.
  • Page 3 Installation Instructions Install Mounting Bar with large screws above the window. Be Caulk sure the bar is level and centered over the window opening. Screws must be in studs or heavy sheathing. (Drill alternate holes in bar if necessary.) Mounting Bar Caulk the top of the Mounting Bar against the house.
  • Page 4 Futureguard®. Under this warranty Futureguard agrees to provide material, repair, refinish, or replace at their sole option, only the parts found to be defective at no cost to the original owner.