Summary of Contents for mtts Otter
- Page 1 User Manual Infant Conductive Warmer Otter 111927727650 2265 Effective date: September 2024 www.mtts-asia.com Issue Number: 01 Version: 00 EN Otter. User manual Issue Date: September 2024...
-
Page 2: Table Of Contents
Contents Company Information Introduction Device Description Safety Information Setting up the Device Using the Device Alarm System Cleaning and Disinfection Maintenance Specifications Explanation of Symbols Warranty Policy V-1-00-EN Otter. User manual... -
Page 3: Company Information
Company Information Introduction Intended purpose The intended purpose of Otter Conductive Warmer is to keep newborn babies normothermic. Otter is de- signed for hospital use only. Intended users a) The device is to be operated by qualified personnel only. b) Knowledge (minimum): •... -
Page 4: Device Description
Skin temperature display (when skin sensor connected) Switchboard Switchboard Base Power Inlet Connect Otter Power Supply. Skin Sensor (optional) Connect Otter Skin Sensor. Press this button to turn Otter display and functions on ON/OFF button and off. V-1-00-EN Otter. User manual... -
Page 5: Safety Information
Contact MTTS. overheating of the patient. • In case of any malfunction DO NOT attempt to service this machine. Otter Con- • The presence of electro-surgical devices, shortwave or microwave equipment near ductive Warmer should only be serviced by a qualified MTTS technician. -
Page 6: Setting Up The Device
Add / remove in series of 3. Caution Keep the equal distribution for better • Only use the cable and connector that is provided by MTTS. balance of the device. • The device should only be used with the power outlets that have a protective earth (ground) pin. -
Page 7: Using The Device
• When the lightly dressed and covered baby is maintaining body temperature with a set point temperature of about 35.5 - 36 C, then the baby is most often ready for a Adjust brightness and volume standard cot that has no warming. Accept selection V-1-00-EN Otter. User manual... -
Page 8: Alarm System
The alarm goes off when the actual temperature exceeds the set point by more than 1 Mute the alarm. Alarm mute is indicated by colour-marked mute symbol. The device can be muted for max 10 min. V-1-00-EN Otter. User manual... - Page 9 1 Caution Turn the machine off and then on again. If the error message is still present, note the error number and contact your MTTS representative. Battery Status and Alarm When the device is connected to AC power Alarm System Test source, the charging status is displayed.
-
Page 10: Cleaning And Disinfection
Caution Bassinet • The Otter bassinet should be disinfected, before and after the treatment of each • Only qualified personnel should carry out service and maintenance procedures. patient. In the case that a patient undergoes treatment for more than one week •... -
Page 11: Specifications
Short Circuit Protection WEEE 2012/19/EU Protection Classes: Class I Safety: IEC 60601-1 Power consumption 120W maximum Battery (internal) Type Li-ion Capacity Optional (30/60/90/120/150 Wh) Power Cords North America (part 50-07302-01) C.E. (part 50-07305-01) U.K. (part 50-09273-01) V-1-00-EN Otter. User manual... -
Page 12: Explanation Of Symbols
Caution: Hazard with a low level of risk, MTTS MAKES NO OTHER EXPRESS WARRANTY OR details. MTTS will not alter form, fit, or function of this which, of not avoided, could result in minor CONDITION WHETHER WRITTEN OR ORAL AND MTTS... - Page 13 MTTS product has recurring failures, MTTS at THE LESSER OF THE PRICE YOU HAVE PAID FOR THE your sales receipt is the date of purchase unless MTTS or ing one of the following: Locate and contact your nearest MTTS service pro-...
- Page 14 House No. 26, Alley 41, An Duong Vuong Street, Tay Ho District, Hanoi City, Vietnam SRN: VN-MF-000036669 Tel: +84 24 3766 6521 Fax: +84 24 3718 8050 Email: assistance@mtts-asia.com www.mtts-asia.com Logic s.r.l. Via Antonio Pigafetta 1 34147 Trieste, Italy SRN: IT-AR-000012301 V-1-00-EN Otter. User manual...
Need help?
Do you have a question about the Otter and is the answer not in the manual?
Questions and answers