CeoTronics CT-DECT M7 Operating Manual page 5

CeoTronics accessories. Follow the audio
device manufacturer's operating instructions
to adjust the signal tones.
Receiver volumes in excess of 85 dB(A) are
possible with a
products but these can be controlled by the
user for safety reasons. After switching on
the communication system, set the receiver
volume to approx. 1/2 of the available
volume and then test the speaker volume,
e.g. by opening the squelch on the radio
device.
Do not set the volume any higher than ne-
cessary. Very high volume settings may
damage hearing, especially over extended
periods of use. At high volumes or noise
levels, wear additional earplugs. If in doubt,
ask your occupational health and safety of-
ficer or company doctor.
Interference with road traffic!
Do not leave CeoTronics products lying
around loose in cars, e.g. on the parcel
shelf. Stow the products in a suitable, safe
place in the car so that they do not present a
danger to you or your passengers in the
event of an emergency stop.
When driving a car, do not operate a radio
because it may distract you from other traffic
and never use a CeoTronics product (head-
set, in-ear headsets, induction receiver etc.)
that impairs your hearing.
Interference with flight
operations!
When on board an aeroplane, always keep
transmitter/receiver devices switched off.
Operation of a transmitter/receiver could af-
fect the safety of the aircraft and is therefore
prohibited. Never operate electronic devices
on board an aircraft without the express ap-
proval of an authorised member of the on-
board personnel.
Always remove the device after the aircraft
intercom announcement. Never remove the
warning label "REMOVE BEFORE FLIGHT"
from CeoTronics products.
range of CeoTronics
dok1263-en-05-10/20
1 General operating and safety instructions
Interference with radio
transmission!
Transmit only when necessary. Unnecessar-
ily occupying a channel can prevent the
transmission of vitally important information.
Danger of explosion!
CeoTronics products that are not intrinsically
safe (explosion-proof) and therefore have no
special explosion-proof designation must
never be operated in potentially explosive
environments. Potentially explosive environ-
ments include, for example, refuelling areas
as well as storage and transport facilities for
fuel and chemicals! Unprotected devices
can cause explosions in those areas!
Strictly adhere to the applicable guidelines,
regulations and requirements for your field
of activity!
Risk of electric shock!
Always remove the mains plug from the
mains socket first before opening mains-op-
erated products (e.g. for service purposes)!
Only use CeoTronics products that are in an
undamaged condition. In case of any kind of
damage, stop using the CeoTronics product
and have it repaired.
Interference with pacemakers!
If you wear a pacemaker, ask the manufac-
turer of your pacemaker for information
about any interference that could be caused
by high frequencies before operating a
transmitter/receiver.
Non-rechargeable and
rechargeable batteries!
Dispose of used batteries free of
charge at your local battery retailer
or collection point or return them to
CeoTronics in accordance with en-
vironmental regulations. Observe the
battery regulation (BattV).
5 / 20