LUCCI Air 197200 Installation Instructions Manual

Installation Instructions
3-IN-1 BATHROOM HEATER / EXHAUST FAN / LIGHT REMOTE
To ensure correct function and safety, please read and follow all instructions carefully before assembly, installation and
use of this product. Please keep the instructions for future reference.
Warranty
• This product is covered by a 12-month warranty. The warranty is from date of purchase, not the date of installation.
• If this product is not installed by a licensed electrician, the warranty will be void.
• Please retain proof of purchase and evidence of installation by a licensed electrician for any warranty enquiries.
• Warranty will be void if there is any damage due to improper usage or modification to the product.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the
warranty.
Installation Requirements
• This product must be installed by a licensed electrician.
• All wiring and installation of this product must adhere to latest local and national wiring rules.
e.g. AS/NZS 3000 Electrical Installations.
• This is a Class I product and must be earthed during wiring and installation.
• An isolation switch must be included in the wiring installation. A circuit breaker can be classified as an isolation switch.
The isolation switch allows disconnecting of the receiver and loads from the mains 240V AC power during maintenance
and cleaning of the connected load.
NOTE:
A double pole wall switch must be included in the wiring installation. The double pole switch allows
the receiver to disconnect from the mains 240V AC power during maintenance and cleaning of the
connected appliance.
NOTE:
Do not install the receiver with an existing wall controller. Remove any existing wall controller and
replace with an isolation switch.
• Do not exceed rated power input specification. See the specifications table at the end of this Installation Instructions.
• Select a suitable location for installation:
−
This product is suitable for indoor use only.
−
The receiver must be installed inside the ceiling cavity.
−
This product is not waterproof. It is rated IP20.
−
Keep away from liquids, dusty, or consistently humid or hot areas.
• This product is suitable for most 3-in-1 bathroom heater, exhaust fan and light appliances.
NOTE:
Do not use any dimmer with the receiver.
NOTE:
The controller wiring circuit must NOT be shared with any electrical equipment that is sensitive to
voltage fluctuation, such as infrared sensor lights.
1 | P a g e
SKU# 197200
Rated Voltage 220-240V~ 50Hz
MUST remove any existing wall controller
(if currently installed)
v 1 . 0 ( 0 5 / 2 0 2 4 )