Page 2 width 2 mm less: 146 mm Battery Chainsaw 1) Work area safety 18V EasiSaw 250 a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. b) Do not operate machines in explosive atmos- Original instructions pheres, such as in the presence of flammable Iiquids, gases or dust.
Page 5
f) Dress properly. Do not wear loose clothing or keys, nails, screws or other small metal objects, jewellery. Keep your hair and clothing away from that can make a connection from one terminal to moving parts. Loose clothes, jewellery or long hair another.
Page 6
If the chain brake does not work, you must not use the of the saw which could result in serious personal injury. chainsaw. In this case, contact FLYMO Service. Do not rely exclusively upon the safety devices built into Rear hand guard [Fig. A1] your saw.
→ The battery can be damaged by sharp objects → If the connecting cable needs replacing, this must be carried out by FLYMO or by such as a nail or screwdriver or by external an authorised after sales service centre for force.
– Close–fitting protective clothing, Risk of injury from an incorrect saw chain or guide bar. – Safety shoes with fixed soles, shock–proof toe caps → Only use original FLYMO saw chains and guide and cut protection, bars. – Gloves with cut protection (protective gloves), You can obtain the spare parts for Art.
2.5 Lubricating the saw chain 7. Guide the saw chain around the sprocket so that the drive links of the saw chain are located in DANGER! sprocket cutouts. 8. Slide the guide bar onto the retaining screw Broken saw chains can cause 9.
Thanks to the intelligent charging process, the charge If the error LED lights up or flashes, condition of the battery is automatically detected and then see 6. TROUBLESHOOTING. charged up with the optimal charge current depending on battery temperature and voltage. In this way, the battery is 3.3 Working position [Fig.
The saw chain shortens as it cools down. This pre- are under tension should be cut from the bottom to the top vents the saw chain from being damaged when it cools to prevent the chainsaw from getting trapped. down. 3.6.5 Sectioning [Fig.
→ Use a soft, clean, dry brush to clean the ventilation slots and the contacts of the battery from time to time. Chainsaw does Chainsaw is defec → Contact FLYMO not start or stops. tive. Service. Error LED 4.3.2 Cleaning the battery charger flashes red [Fig.
50–60 Mains frequency Repairs must only be done by FLYMO service departments or specialist dealers approved by FLYMO. Rated Power → Please contact your FLYMO service centre in the event Battery charging of other faults (see reverse). V (DC) voltage 7.
Li-ion 1. Discharge the lithium-ion cells fully (contact FLYMO Service about this). 2. Ensure that the lithium-ion cell contacts do not short-circuit by placing tape over them.
Page 15
Declaration of Conformity [only for UK] The manufacturer, FLYMO Germany AB PO Box 7454 S-103 92 Stockholm Sweden, hereby certifies, when leaving our factory, the unit(s) indicated below is / are in accordance with the UK Regulations, designated standards of safety and product specific designated standards. This certificate becomes void if the units are modified without our approval.
Need help?
Do you have a question about the EasiSaw 250 and is the answer not in the manual?
Questions and answers