Solight 5B350 Quick Start Manual

EN 5B350
230V~/16A socket with IP66 protection class
Thank you for purchasing our product. Please read this manual carefully and heed the safety warnings and instructions before installing, using or
repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.
Protection class (coverage) IP66 is one of the highest protections against electric shock, dust and water. This means that the socket and the power
cord plugged into it are completely protected against electric shock in case of dangerous contact with a tool or wire larger than 1 mm, they are
completely protected against dust and they are protected against intense jets of water at all angles.
Supplied mounting accessories:
4pcs M4x27 cross head screw
4pcs M4x30 Phillips head screw
6 pcs M3x8 screw with countersunk head
3pcs mounting bracket
4pcs waterproof plugs for rear box
4 pcs waterproof plugs for top cover
3 pcs waterproof screw plug
4 pcs dowel
1. Installing the rear box
Method 1
Use a spirit level to draw a horizontal line on the wall. Break out the rear box mounting holes. Align the edge of the rear box with the horizontal line.
Mark the center of each mounting hole on the wall and drill the holes according to the marked positions. Insert the dowels into the holes and attach
the rear box to the wall with M4x27 screws. Finally, cover the mounting holes of the rear box with waterproof plugs.
See Figure 1a.
Method 2
Place the 3pcs mounting bracket on the corresponding places of the rear box and fix them with M3x8 screws. Use a spirit level to draw a parallel line
on the wall. Align the edge of the rear box with the parallel line. Mark the positions of the mounting bracket holes on the wall and drill the holes
according to the marked positions. Insert the dowels into the holes and attach the rear box to the wall with M4x27 screws.
See Figure 1b.
2. Connection
Turn off the mains power to the lead cable before installation. Remove the insulation of all wires to a length of max. 12mm ± 1mm. Select a suitable
waterproof cable gland and thread the cable through it. Unscrew the cover of the rear box and thread the cable inside. Plug the individual wires into
the sockets of the socket in the upper cover, correctly according to the installation needs. Make sure the wires are adequately secured. Screw and
seal the cable gland to the rear box. Installation may only be performed by an authorized person.
See Figure 2.
3. Assembly of the cover
Put the top cover on, align the screw holes in the cover with the holes in the rear box and fasten the M4x30 screws.
Fit waterproof plugs to the holes in the top cover.
See Figure 3.
4. Usage
Press the latch of the top cover to open it. Connect the plug of the power cable and place it in the middle of the rubber seal of the cable outlet. Close
the cover and make sure the latch is properly secured. The cover can be locked with a padlock to ensure safety and to protect against unwanted
manipulation. Open and disconnect the cable in reverse order.
See Figure 4.
Do not change the internal connection unprofessionally, do not exceed the permissible load, clean only disconnected from the mains, let it dry
thoroughly. The company Solight Holding s.r.o. is in no way responsible for property damage and personal injury caused by unprofessional installation
.
or incorrect use
Required mounting accessories as needed:
waterproof screw cable gland
Phillips screwdriver
spirit level and marker
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Česká republika.