Pioneer CT-X420W Operating Instructions Manual

Mode d% a.
Istruzioni per Iu:
ola
@ PIONEER srenco couse cassette TAPE DECK CT-KaPOW
A
al © L) 2 | |
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the ex-
planatory drawings. However, the method of connecting and
operating the unit is the same.
WARNING: To preveENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this
switch. U.S., Canadian, European, U.K., and Australian
models are not provided with this switch.
The line voltage selector switch is on the rear panel. Before
your model is shipped from the factory, this switch is set to .
the power requirements of the destination. Check that it is set
properly before plugging the power cord into the AC outlet. If
the voltage is not properly set or if you move to an area where
the voltage requirements differ, adjust the selector switch as
follows.
1. Disconnect the power cord.
2. Use a medium-size screwdriver.
Medium-size screwdriver
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/8839/EEC and
82/499/EEC."'
PIONEER