Page 1
(03) 9466 9000 t (02) 9531 2100 t (08) 9249 5464 t (07) 3363 2400 t 1300 764 744 e vic@britex.com.au e nsw@britex.com.au e wa@britex.com.au e qld@britex.com.au e sa@britex.com.au PCAM Installation Guide | QID 1.20 | Rev 2 | 16 Dec 2024...
Page 2
3. If the WC Pan is damaged in transit or if any details are not as requested, do not install it. Notify Britex immediately within 24 hours of receipting the product. Note: No power tools are recommended for use with access panel screws. Britex advises use of supplied security torx allen key only.
Page 3
DO NOT SCALE DRA New S Trap Shown 26/10/22 DIMENSIONS ARE IN MILLIMETERS 50mm OD Pipe 100mm Outlet 80-100 S Trap Shown Australia’s Finest Stainless | britex.com. PCAM Installation Guide | QID 1.20 | Rev 2 | 16 Dec 2024 Floor Fixing Bracket...
With pan in place, mark where offset floor fixing bracket is required. Remove pan and fix bracket to floor, see figure (b). TITLE: Drawing: UNLESS OTHERWISE S DIMENSIONS ARE IN M Australia’s Finest Stainless | britex.com. PCAM Installation Guide | QID 1.20 | Rev 2 | 16 Dec 2024...
Page 5
Installation Instructions 2. Pan is supplied standard with concealed rear inlet to suit flushing mechanisms. Britex recommends the Sigma 8 in-wall cistern as a flushing device. Flushing device needs to be installed as per the instructions that are provided. 3. For S-trap configuration, install provided S trap to pan waste outlet then connect to in ground waste plumbing.
Once all dirt, oil and grime is removed, rinse thoroughly with clean water and wipe dry. Australia’s Finest Stainless | britex.com. PCAM Installation Guide | QID 1.20 | Rev 2 | 16 Dec 2024...
BRITEX at no charge, provided that the terms of the manufacturer’s warranty are followed. This warranty is the only warranty given by BRITEX, and we expressly disclaim all other warranties, including but not limited to implied warranties of merchantability and fitness for a particular purpose.
Page 12
(03) 9466 9000 t (02) 9531 2100 t (08) 9249 5464 t (07) 3363 2400 t 1300 764 744 e vic@britex.com.au e nsw@britex.com.au e wa@britex.com.au e qld@britex.com.au e sa@britex.com.au PCAM Installation Guide | QID 1.20 | Rev 2 | 16 Dec 2024...
Need help?
Do you have a question about the PCAM and is the answer not in the manual?
Questions and answers