Table of Contents
Advertisement
3.3
Adjusting Audio Settings
1
Press MENU to enter the OSD Main
Menu screen.
2
Press
/
on the remote control or
CH
/ CH
on the control panel to select
Audio menu.
3
Press
/ OK on the remote control or
INPUT on the control panel to enter the
Audio menu.
4
Press
/
on the remote control or CH
an item.
5
Press
/ OK on the remote control or INPUT on the control panel to enter the item.
6
Press
/
on the remote control or
the scales or press OK on the remote control or INPUT on the control panel to mark
an item.
7
Press RETURN to return to the Audio menu.
8
Press MENU to exit the Audio menu.
9
The Audio menu can be used to adjust the Audio Mode, Equalizer, Balance, DRC
(DTV only), MTS (ATV only), Auto Volume (ATV only), and Recall settings.
Equalizer is available for adjustment only if you select User in Audio Mode.
•The Audio Mode can be set to Dynamic,
•Press
/
on the remote control or
the scales in Equalizer and Balance.
•The DRC (Dynamic Range Control) can be set to RF Mode or Line Mode.
•The MTS can be set to
•The Recall can be used to reset the original factory settings.
Note:
The items available on the OSD may vary depending on the input signal source.
32
Picture
Audio
Channel
V-CHIP
Setup
VOL+
/
Standard
VOL+
Stereo
, Mono, or SAP.
Audio Mode
Equalizer
Balance
MTS
Auto Volume
Recall
Move
Enter
Return
OK
Return
/ CH
on the control panel to select
VOL-
on the control panel to change
, Soft, or User.
VOL-
/
on the control panel to adjust
Exit
Menu
Advertisement
Table of Contents
