Ronstan S22 Manual

Certified to:
European Standard EN795:2012, Type D: Personal fall protection equipment – Anchor Devices.
European Technical Specification CEN/TS16415:2013, Type D: Personal fall protection equipment – Anchor Devices
– Recommendations for anchor devices for use by more than one person simultaneously.
Australian Standard AS1891.2:2001: Industrial fall-arrest systems and devices; Part 2: Horizontal lifeline and rail
systems.
A reliable anchor device is an essential component of
any personal protection system.
This system provides a method of attachment for use
in conjunction with personal protection equipment to
protect against falls from a height, such as when
working outside of conventional guardrails for cleaning
and maintenance purposes. It shall not be used for
lifting equipment or for any other purpose.
Important Advice
The system is tested to the European standard EN795:2012 Type D, the European Technical Specification
•
CEN/TS16415:2013 Type D, and the Australian Standard AS1891.2.2001. The system is appropriate for use by
up to a maximum of three persons simultaneously, with one dedicated car for each individual user. Testing for
conformity to these standards is witnessed by a Recognised Organisation, member of the International
Association of Classification Societies (IACS).
This anchor device is designed for the attachment of components of a personal fall protection system
•
(harnesses, lanyards, fall arresters and other devices) in accordance with EN363, Personal fall protection
equipment – Personal fall protection systems, and/or AS1891.1 or AS1891.3.
Each harness or device must be secured to a separate attachment point.
•
If this anchor device is to be used as part of a fall arrest system, the user must be equipped with a means of
•
limiting the maximum dynamic forces exerted on the user during the arrest of a fall to a maximum of 6KN.
If this anchor device is to be used as part of a "Rope access" type fall protection system, as described in EN363,
•
where the user's weight while working or accessing the work site is supported by the anchor device, a dedicated
tandem car providing separate attachment points for both the working line and fall arrest safety line, together
with a suitable fall arrester and harness, is required for each user. (Figure 1).
If this anchor device is to be used as part of a "Restraint" or "Fall Arrest" type fall protection system, as described
•
in EN363, a single car may be used to provide an attachment point for the fall arrest safety line, together with a
suitable fall arrester and harness. (Figures 2 & 3).
Figure 1: EN363 "Rope
Access" system example.
Ronstan International Pty Ltd
19 Park Way, Braeside, Victoria 3195 Australia
Tel: +61 (0)3 8586 2000 / Email: office@ronstan.com.au
E.U. Representative: Ronstan Denmark ApS
Jægervænget 36, 7100 Vejle, Denmark
Tel: (45) 76 42 77 77 / Email: office@ronstan.dk
SAFETY RAIL SYSTEM S22
Figure 2: EN363 "Restraint"
system example.
Figure 3: EN363 "Fall
Arrest" system example.
ISSUED 08/08/2024
1