Advertisement
Advertisement
Table of Contents
Related Manuals for FLIR EV45 Series
Summary of Contents for FLIR EV45 Series
- Page 1 QUICK START EV Charger Test Adapter MODELS EV45-NACS and EV45–T2...
-
Page 3: Safety Warnings
Introduction Thank you for your purchase of the FLIR EV45 Series Charger Test Adapter. The EV45 series is rated CAT II 300 V and is compliant with IEC 61851–1 (EV Safety). This Quick Start provides brief information to get you started, down- load the user manual from the FLIR website for complete instructions. - Page 4 Descriptions Protective cap for plug Colour display PE PRE-TEST pad Green (PASS), Red (FAULT) Control buttons Rotary selector switch Output terminals Proximity Pilot (PP) indicates charger max. rated current Control Pilot (CP) states: A (dis- connected), B (connected, not charging), C (charging), D (charging with ventilation), E (error) Battery power...
-
Page 5: Quick Steps
Quick Steps CONNECTIONS • Plug the EV45 into the charging station port. Use the supplied converter to match the plug type, if necessary. • Initialize the charging station. For commercial chargers, this is typically done by scanning a QR code using a charging mobile app. - Page 6 2. Wait 3 seconds and place your finger on the PE PRE-TEST pad to perform the protective earth test. The display will flash PASS or FAULT 3 times on the lower right. Remove your finger. 3. If FAULT is displayed, the charging system ground circuit is mal- functioning and cannot be tested.
-
Page 7: Battery Power
3. If FAULT is displayed, the charger did not respond correctly to a simulated protective earth error and so it must be serviced. CP ERROR TEST 1. Press the E STATE button > 2 seconds. The display will show CP ERROR and flash PASS or FAULT. If the CP state is not de- tected in 3 seconds, the CP state will show E (error). -
Page 8: Specifications
First connect the EV45 to the charging station and then connect the DMM to the EV45. If you pur- chased a kit (EV-KIT-1 or EV-KIT-2), it includes the FLIR DM286 DMM. See EV45 and DM286 user manuals for complete details. -
Page 9: Electrical Tests
ELECTRICAL TESTS Protective Earth (PE) Passes when < 50 V AC/DC is detected pre-test Proximity Pilot (PP) OPEN or current measurement up to 63 A states Control Pilot (CP) A (Disconnected) , B (Connected) , C (Charging), states D (Charging w/ ventilation), E (Error) Voltage phase Three phase (EV45–T2);... -
Page 10: Customer Support
Customer Support Customer Support Telephone List https://support.flir.com/contact Repair, Calibration, and Technical Support https://support.flir.com Warranty This product is protected by FLIR’s Limited Three-Year Warranty. Visit www.flir.com/testwarranty to read the warranty document. #NAS1002159; r. AB/102838/102838; en-GB... -
Page 12: Quick Start
Customer support http://support.flir.com Copyright © 2025, FLIR Systems, Inc. All rights reserved worldwide. Disclaimer Specifications subject to change without further notice. Models and accessories subject to regional market considerations. License procedures may apply. Products described herein may be subject to US Export Regulations. Please refer to exportquestions@flir.com with any questions.
Need help?
Do you have a question about the EV45 Series and is the answer not in the manual?
Questions and answers